Discussion
Home ‣ Civil Engineering ‣ Concrete Technology Comments
- Question
The final operation of finishing floors, is known as
Options- A. screeding
- B. floating
- C. trowelling
- D. finishing
- E. all the above.
- Correct Answer
- trowelling
- 1. Segregation is responsible for
Options- A. honey-combed concrete
- B. porous layers in concrete
- C. surface scaling in concrete
- D. sand streaks in concrete
- E. all the above. Discuss
- 2. The grade of concrete not recommended by I.S. : 456, is
Options- A. M 100
- B. M 200
- C. M 300
- D. M 400
- E. M 500 Discuss
- 3. For construction of structures in sea water, the cement generally preferred to, is
Options- A. Portland-pozzolana cement
- B. quick setting cement
- C. low heat Portland cement
- D. rapid hardening cement
- E. none of these. Discuss
- 4. Addition of pozzolana to cement
Options- A. decreases workability
- B. increases strength
- C. increases heat of hydration
- D. decreases curing time
- E. none of these. Discuss
- 5. Specified compressive strengh of concrete is obtained from cube tests at the end of
Options- A. 3 days
- B. 7 days
- C. 14 days
- D. 21 days
- E. 28 days. Discuss
- 6. The produce impermeable concrete
Options- A. thorough mixing of concrete is required
- B. proper compaction of concrete is required
- C. proper curing of concrete is required
- D. properly graded and non-porous aggregates are requied
- E. all the above. Discuss
- 7. According to the recommendations of IS : 456-1978, the expansion joints
Options- A. are provided where plane changes abruptly
- B. are provided to ensure minimum resistance
- C. are supported on separate columns
- D. do not carry reinforcement across them
- E. all the above. Discuss
- 8. The datum temperature for maturity by Plowman, is
Options- A. 23°C
- B. 0°
- C. - 5.6°C
- D. - 11.7°C Discuss
- 9. For an ordinary Portland cement
Options- A. residual does not exceed 10% when sieved through IS Sieve No. 9
- B. soundness varies from 5 to 10 mm
- C. initial setting time is not less than 30 minutes
- D. compressive stress after 7 days, is not less than 175 kg/cm2
- E. all the above. Discuss
- 10. Workability of concrete for a given water content is good if the aggregates, are
Options- A. rounded aggregate
- B. irregular aggregate
- C. angular aggregate
- D. flaky aggregates. Discuss
Concrete Technology problems
Search Results
Correct Answer: all the above.
Correct Answer: M 500
Correct Answer: Portland-pozzolana cement
Correct Answer: none of these.
Correct Answer: 28 days.
Correct Answer: all the above.
Correct Answer: all the above.
Correct Answer: - 11.7°C
Correct Answer: initial setting time is not less than 30 minutes
Correct Answer: rounded aggregate
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.