logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Building Construction Comments

  • Question
  • The process of filling hollow spaces of walls before plastering, is known


  • Options
  • A. hacking
  • B. dubbing out
  • C. blishering
  • D. peeling
  • E. all the above.

  • Correct Answer
  • dubbing out 


  • Building Construction problems


    Search Results


    • 1. The type of arch used for high class buildings where appearance is of prime importance, is known as

    • Options
    • A. ashlar arch
    • B. rubble arch
    • C. gauged brick arch
    • D. axed brick arch.
    • Discuss
    • 2. Slate

    • Options
    • A. is a metamorphic rock
    • B. splits into thin sheets along its bedding planes
    • C. has a smooth surface and contains alumina and silica
    • D. possesses good water absorption capacity
    • E. is found in many colours.
    • Discuss
    • 3. A concrete structure is set on fire and the temperature raises to 1000°C. The strength of concrete as compared to original strength reduces to

    • Options
    • A. 10%
    • B. 15%
    • C. 20%
    • D. 25%.
    • Discuss
    • 4. The service area in a building means the area occupied by

    • Options
    • A. stairs
    • B. toilets
    • C. light and shafts
    • D. all the above.
    • Discuss
    • 5. The vertical faces of a door opening which support frame of the door, are

    • Options
    • A. jambs
    • B. posts
    • C. reveals
    • D. styles.
    • Discuss
    • 6. A wooden block fixed on back side of a door frame on its post, is known as

    • Options
    • A. cleat
    • B. stop
    • C. horn
    • D. none of these.
    • Discuss
    • 7. The window which is provided in flat roof of a room, is known

    • Options
    • A. dormer window
    • B. lantern window
    • C. louvered window
    • D. sky window.
    • Discuss
    • 8. Pick up the correct statement from the following :

    • Options
    • A. The bearing capacity of a pile is defined as the load which can be sustained by the pile without producing excessive settlement
    • B. The ultimate bearing capacity of a pile is defined as the maximum load which the pile carries and continues to sink without any further increases of load
    • C. The safe bearing capacity of a pile is obtained by dividing the ultimate bearing capacity with a suitable factor of safety
    • D. The factor of safety for piles is taken as 6
    • E. All the above.
    • Discuss
    • 9. Pick up the correct statement from the following :

    • Options
    • A. sand consists of coarse particles of silica formed due to the disintegration of rocks.
    • B. the grains of sand are not affected by frost
    • C. sand beds are permeable and do not allow water to rise up between pores due to capillary action
    • D. all the above.
    • Discuss
    • 10. The sill of a common wooden partition is

    • Options
    • A. vertical wooden member on either end
    • B. lower horizontal wooden member
    • C. upper horizontal wooden member
    • D. intermediate horizontal wooden member.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment