Discussion
Home ‣ Civil Engineering ‣ Elements of Remote Sensing Comments
- Question
Depending upon the nature of the targeted object and the wave length of the electromagnetic radiation incident on it, the radiation gets :
Options- A. reflected
- B. absorbed
- C. re-radiated
- D. transmitted through
- E. All of these
- Correct Answer
- All of these
- 1. For obtaining accurate distance of the satellite
Options- A. the GPS receiver slides its codes backwards until it synchronises with the satellite signals
- B. the signal arrival time is corrected for tropospheric and ionospheric delays
- C. the carrier phase measurement technique is adopted
- D. All of these Discuss
- 2. Snow consists of
Options- A. snow crystals
- B. rimed snow crystals
- C. snow flakes
- D. All of these Discuss
- 3. "All bodies at temperatures above absolute zero degree emit electromagnetic radiation at different wave length", is known as:
Options- A. Plank's law
- B. Planktan's law
- C. Lambert's cosine law
- D. None of these Discuss
- 4. The leaf area index (LAI) is :
Options- A. one sided leaf area per unit area of the ground
- B. two sided leaf area per -unit area of the ground
- C. the average of the two sided area per unit area of the ground
- D. None of these Discuss
- 5. Which one of the following frequencies is a GPS?
Options- A. L1 with frequency 1520 MHz
- B. L1 with frequency 1575.42 MHz
- C. L1 with frequency 1227.6 MHz
- D. L1 with frequency 1280.43 Hz Discuss
- 6. The solid angle subtended by the sphere is :
Options- A. 2?
- B. 3?
- C. 4?
- D. 6? Discuss
- 7. Assuming n as the frequency of radiation, n0 as the threshold frequency and k as a constant, the energy of the photo-electrons (E) is related as
Options- A. E = k (n - n0)
- B. E = k (n + n0)
- C. E = k (n x n0)
- D.
Discuss
- 8. The various stages of formation of snow are listed below :
1. Formation of ice crystals
2. Formation of snow pallets
3. Formation of snow flakes
4. Formationof snow crystals
5. Formation of rimed crystals
Which one of the following sequences is correct?
Options- A. 3 2 5 1 4
- B. 5 3 1 2 4
- C. 1 4 3 5 2
- D. 1 3 4 2 5 Discuss
- 9. Remote sensing techniques are being usefully employed for the purpose of:
Options- A. improving natural resource management
- B. land use
- C. protection of the environment
- D. All of these Discuss
- 10. You are asked to design and supervise a truss for a factory to have spans 6 m to 9 m. The type of the truss you will use, is
Options- A. mansored truss
- B. queen post truss
- C. king post truss
- D. collar truss
- E. none of these. Discuss
Elements of Remote Sensing problems
Search Results
Correct Answer: the carrier phase measurement technique is adopted
Correct Answer: All of these
Correct Answer: Plank's law
Correct Answer: one sided leaf area per unit area of the ground
Correct Answer: L1 with frequency 1575.42 MHz
Correct Answer: 4?
Correct Answer: E = k (n - n0)
Correct Answer: 1 4 3 5 2
Correct Answer: All of these
Correct Answer: king post truss
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.