logo

CuriousTab

CuriousTab

Discussion

Home ‣ Civil Engineering ‣ Theory of Structures Comments
  • Question

  • The locus of the moment of inertia about inclined axes to the principal axis, is


  • Options
  • A. straight line
  • B. parabola
  • C. circle
  • D. ellipse.

  • Correct Answer
  • ellipse. 

    • Theory of Structures problems

    Search Results

    • 1. In a shaft, the shear stress is not directly proportional to

    • Options
    • A. radius of the shaft
    • B. angle of twist
    • C. length of the shaft
    • D. modulus of rigidity.
      • Discuss
    • 2. Ab and Ac are the cross sections of bronze and copper bars of equal length, ?b, ?c are their respective stresses due to load P. If Pb and Pc are the loads shared by them, (where Eb and Ec are their modulii).

    • Options
    • A.
    • B. P = Pb + Pc
    • C. P = Ab ?b + Ac ?b
    • D. all the above
      • Discuss
    • 3. The load on a spring per unit deflection, is called

    • Options
    • A. stiffness
    • B. proof resilience
    • C. proof stress
    • D. proof load.
      • Discuss
    • 4. A simply supported beam A carries a point load at its midspan. An other identical beam B carries the same load but uniformly distributed over the entire span. The ratio of the maximum deflections of the beams A and B, will be

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 5. The moment of inertia of a circular section about any diameter D, is

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 6. The equivalent length of a column of length L, having one end fixed and other end hinged, is

    • Options
    • A. 2L
    • B. L
    • C.
    • D.
      • Discuss
    • 7. The maximum height of a masonry dam of a triangular section whose base width is b and specific gravity s, is

    • Options
    • A. bs
    • B. b.s
    • C. bs
    • D. s b
    • E.
      • Discuss
    • 8. The locus of the end point of the resultant of the normal and tangential components of the stress on an inclined plane, is

    • Options
    • A. circle
    • B. parabola
    • C. ellipse
    • D. straight line.
      • Discuss
    • 9. The forces acting normally on the cross section of a bar shown in the given figure introduce

    • Options
    • A. compressive stress
    • B. tensile stress
    • C. shear stress
    • D. none of these.
      • Discuss
    • 10. The ratio of the length and depth of a simply supported rectangular beam which experiences maximum bending stress equal to tensile stress, due to same load at its mid span, is

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.