logo

CuriousTab

CuriousTab

Discussion

Home ‣ Civil Engineering ‣ Theory of Structures Comments
  • Question

  • m1 and m2 are the members of two individual simple trusses of a compound truss. The compound truss will be rigid and determinate if


  • Options
  • A. m = m1 + m2
  • B. m = m1 + m2 + 1
  • C. m = m1 + m2 + 2
  • D. m = m1 + m2 + 3

  • Correct Answer
  • m = m1 + m2 + 3 

    • Theory of Structures problems

    Search Results

    • 1. A steel bar 20 mm in diameter simply-supported at its ends over a total span of 40 cm carries a load at its centre. If the maximum stress induced in the bar is limited to N/mm2, the bending strain energy stored in the bar, is

    • Options
    • A. 411 N mm
    • B. 511 N mm
    • C. 611 Nmm
    • D. 711 N mm
      • Discuss
    • 2. The force in EC of the truss shown in the given figure, is

    • Options
    • A. zero
    • B. 5t tension
    • C. 5t compression
    • D. 4t tension
    • E. None of these.
      • Discuss
    • 3. A shaft subjected to a bending moment M and a torque T, experiences

    • Options
    • A. maximum bending stress =
    • B. maximum shear stress =
    • C. both (a) and (b)
    • D. neither (a) nor (b)
      • Discuss
    • 4. If M, I, R, E, F, and Y are the bending moment, moment of inertia, radius of curvature, modulus of elasticity stress and the depth of the neutral axis at section, then

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 5. Gradually applied static loads do not change with time their

    • Options
    • A. magnitude
    • B. direction
    • C. point of application
    • D. all the above.
      • Discuss
    • 6. If the normal stresses due to longitudinal and transverse loads on a bar are ?1 and ?2 respectively, the tangential component of the stress on an inclined plane through ?°, the longitudinal load is

    • Options
    • A. ?1 sin ? + ?2 cos ?
    • B. ?1 sin ?2 + ?2 cos2 ?
    • C.
    • D.
      • Discuss
    • 7. A compound truss may be formed by connecting two simple rigid frames, by

    • Options
    • A. two bars
    • B. three bars
    • C. three parallel bars
    • D. three bars intersecting at a point.
      • Discuss
    • 8. The radius of gyration of a rectangular section (depth D, width B) from a centroidal axis parallel to the width is

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 9. The ratio of the section modulus of a square section of side B and that of a circular section of diameter D, is

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 10. In case of a simply supported I-section beam of span L and loaded with a central load W, the length of elasto-plastic zone of the plastic hinge, is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E. none of these.
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.