logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Railways Comments

  • Question
  • The effective bearing area of all types of sleepers, is


  • Options
  • A. 0.40 m2
  • B. 0.42 m2
  • C. 0.44 m2
  • D. 0.46 m2
  • E. 0.50 m2

  • Correct Answer
  • 0.46 m2 


  • Railways problems


    Search Results


    • 1. In a diamond crossing, number of noses are

    • Options
    • A. 2
    • B. 3
    • C. 4
    • D. 6
    • Discuss
    • 2. For inspection and packing of ballast, each pot sleeper is provided with

    • Options
    • A. one hole
    • B. two holes
    • C. three holes
    • D. four holes.
    • Discuss
    • 3. Minimum composite sleeper index for wooden sleepers used over bridge girders, is

    • Options
    • A. 1455
    • B. 1355
    • C. 1255
    • D. 1155
    • E. none of these.
    • Discuss
    • 4. Minimum gradient in station yards is generally limited to

    • Options
    • A. 1 in 1000
    • B. 1 in 750
    • C. 1 in 500
    • D. 1 in 400
    • E. zero
    • Discuss
    • 5. If the standard length of a B.G. crossing is 597 cm, the number of crossing, is

    • Options
    • A. 1 in
    • B. 1 in 12
    • C. 1 in 16
    • D. none of these.
    • Discuss
    • 6. In Indian railways, the ratio of axle load and weight of rail, is

    • Options
    • A. 312
    • B. 412
    • C. 512
    • D. 600
    • Discuss
    • 7. If D is the distance between parallel tracks G is the gauge and ? is angle of crossings, the distance between theoretical noses of two crossings measured parallel to tracks, is

    • Options
    • A. (D - G - G sec ?) cot ?
    • B. (D - G + G sec ?) cot ?
    • C. (D - G - G sec ?) tan ?
    • D. (D + G + G sec ?) cot ?
    • Discuss
    • 8. If a is average number of peaks more than 10 mm of uneveness per kilometre, b is average number peaks more than 6 mm for gauge variation per kilometre and c is average number of peaks more than 2 mm twist per metre, then composite current recording index (Ic), as recommended by Indian Northern Railways, is

    • Options
    • A. Ic = 10 - a - b - c/4
    • B. Ic = 20 - a - b - c/4
    • C. Ic = 30 - a - b - c/4
    • D. Ic = 40 - a - b - c/4
    • Discuss
    • 9. For points and crossings, maximum size of ballast, is

    • Options
    • A. 50 mm
    • B. 40 mm
    • C. 30 mm
    • D. 25 mm
    • E. 20 mm
    • Discuss
    • 10. The rails get out of their original positions due to insufficient expansion gap. This phenomenon is known

    • Options
    • A. hogging
    • B. buckling
    • C. creeping
    • D. none of these.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment