logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Railways Comments

  • Question
  • Packing of ballast is done


  • Options
  • A. near the ends of sleepers
  • B. on the shoulders
  • C. under sleepers
  • D. between two rails.

  • Correct Answer
  • under sleepers 


  • Railways problems


    Search Results


    • 1. Main disadvantage of steel sleepers, is :

    • Options
    • A. it gets rusted quickly
    • B. its lugs some times get broken
    • C. its lugs some times get split
    • D. all the aboye.
    • Discuss
    • 2. In India, metre gauge permanent way was adopted in

    • Options
    • A. 1855
    • B. 1860
    • C. 1866
    • D. 1871
    • E. 1875
    • Discuss
    • 3. The factor for deciding the type of sleeper, is

    • Options
    • A. easy fixing and removal of rails
    • B. provision of sufficient bearing area for rails
    • C. initial and maintenance costs
    • D. strength to act as a beam under loads
    • E. all the above.
    • Discuss
    • 4. For an effective administration, Indian railway system has been divided into

    • Options
    • A. four railway zones
    • B. six railway zones
    • C. seven railway zones
    • D. eight railway zones
    • E. nine railway zones.
    • Discuss
    • 5. On either side of the centre line of rails, a cant of 1 in 20 in the sleeper is provided for a distance of

    • Options
    • A. 150 mm
    • B. 165 mm
    • C. 175 mm
    • D. 185 mm
    • Discuss
    • 6. To prevent creep in rails, the steel sleepers are fixed with rails by clips, bolts and

    • Options
    • A. one key
    • B. two keys
    • C. three keys
    • D. four keys.
    • Discuss
    • 7. 30 m long rails are used in

    • Options
    • A. India
    • B. Pakistan
    • C. Russia
    • D. U.S.A.
    • E. U.K.
    • Discuss
    • 8. If D is the distance between the parallel sidings and ? is the angle of crossing, the distance between the noses of crossing measured parallel to the main track, is

    • Options
    • A. D tan ?
    • B. D sec ?
    • C. D cosec ?
    • D. D cot ?
    • Discuss
    • 9. On Broad Gauge main lines with maximum traffic loads, the rail section preferred to, is

    • Options
    • A. 29.8 to 37.3 kg/m
    • B. 32.5 to 42.5 kg/cm
    • C. 44.7 to 56.8 kg/m
    • D. none of these
    • Discuss
    • 10. The main function of sleepers, is

    • Options
    • A. to support rails
    • B. to hold rails at correct gauge
    • C. to distribute load from the rails to ballast
    • D. all the above.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment