logo

CuriousTab

CuriousTab

Discussion

Home ‣ Civil Engineering ‣ Railways Comments
  • Question

  • On Indian Railways, angle of crossing between gauge faces of Vee, is generally calculated by


  • Options
  • A. Cole's method
  • B. Centre line method
  • C. Isosceles triangle method
  • D. both (a) and (b)

  • Correct Answer
  • Cole's method 

    • Railways problems

    Search Results

    • 1. In a railway track, permissible gauge with tolerance under loaded condition, is

    • Options
    • A. G + 0.1 mm
    • B. G + 1.5 mm
    • C. G - l.O mm
    • D. G - 1.5mm
    • E. G - 20 mm
      • Discuss
    • 2. If G is gauge distance and a is crossing, the distance between the nose of acute crossing and nose of obtuse crossing of a rail diamond, measured along the rail not forming the diamond, is

    • Options
    • A. G cot ?
    • B. G tan ?
    • C. G sin ?
    • D. G cos ?
      • Discuss
    • 3. Sand may be used as ballast for

    • Options
    • A. wooden sleepers
    • B. steel sleepers
    • C. cast iron sleepers
    • D. all the above.
      • Discuss
    • 4. To avoid the damage of nose of crossing, the wing rails are ramped so that nose of crossing remains at a lower level by

    • Options
    • A. 3 mm
    • B. 4 mm
    • C. 5 mm
    • D. 6 mm.
      • Discuss
    • 5. Pick up the incorrect statement from the following. Required tilt of 1 in 20 is provided

    • Options
    • A. to the tops of rails
    • B. at rail seats in bearing plates
    • C. at rail seats in chairs
    • D. at rail seats in metal sleepers.
      • Discuss
    • 6. If w is width of sleepers, s is sleeper spacing and d is depth of ballast then

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
      • Discuss
    • 7. Weight and cross section of the rails are decided on

    • Options
    • A. gauge of tracks
    • B. speed of trains
    • C. spacing of sleepers
    • D. type of rails
    • E. all the above.
      • Discuss
    • 8. For even distribution of load through ballast, load dispersal is assumed as

    • Options
    • A. 30° to the vertical
    • B. 45° to the vertical
    • C. 60° to the vertical
    • D. none of these.
      • Discuss
    • 9. Check rails are provided on inner side of inner rails if sharpness of a B.G. curve, is more than

    • Options
    • A. 3°
    • B. 5°
    • C. 6°
    • D. 8°
      • Discuss
    • 10. On Indian Railways, the approximate weight of a rail section is determined from the formula

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.