Discussion
Home ‣ Civil Engineering ‣ Railways Comments
- Question
Cast iron sleeper, is
Options- A. pot sleeper
- B. box sleeper
- C. Duplex sleeper
- D. plate sleeper
- E. All the above.
- Correct Answer
- All the above.
- 1. The lengths of the standard crossings in India for Broad gauge and Metre gauge tracks is same for
Options- A. 1 in
B.G. and, in 12 M.G. - B. 1 in 12 B.G. and, 1 in 16 M.G.
- C. 1 in 12 B.G. and 1 in M.G.
- D. 1 in 16 B.G. and 1 in 12 M.G. Discuss
- 2. If D is distance between centres of two parallel tracks of gauge G with entire curved leads and equal angles of crossing, total length of crossover, is
Options- A. D (4R - 2G - D)
- B. D (3R - 2G -D)
- C. D (3R + 2G - D)
- D. D (4 + 2G - D) Discuss
- 3. The gradient on which an additonal engine is required to negotiate the gradient, is called
Options- A. momentum gradient
- B. pusher gradient
- C. ruling gradient
- D. steep gradient. Discuss
- 4. Pick up the incorrect statement from the following:
Options- A. Ends of adjoining rails should be in true alignment
- B. Rail joints should be as strong as the rail section itself
- C. Rail joints should be elastic laterally as well as vertically
- D. Ends of adjoining rails butt against to give a continuity
- E. All the above. Discuss
- 5. An extra 7.5 cm ballast width is not provided on outer side on a curve, if its degree is
Options- A. 6°
- B. 5°
- C. 4°
- D. 3°
- E. 2° Discuss
- 6. In permanent way, ballast
Options- A. transfers load from sleepers to the formation
- B. provides an elastic bed to the track
- C. provides a drainage of track
- D. all the above. Discuss
- 7. On Indian Railways, number of a crossing is defined as
Options- A. sine of angle of crossing
- B. consine of angle of crossing
- C. tangent of angle of crossing
- D. contangent of angle of crossing. Discuss
- 8. Anti-creep anchors are fixed to rails by
Options- A. wedging
- B. spring grip
- C. clamping
- D. all the above. Discuss
- 9. Pick up the correct statement from the following:
Options- A. Length of tongue rail should be greater than rigid wheel base of vehicle
- B. Stock rail should be longer than tongue rail
- C. Length of stock rail ahead of the toe should be a minimum of 1.65 m
- D. All the above. Discuss
- 10. Track construction involves preparation of
Options- A. subgrade
- B. plate laying
- C. ballasting
- D. all the above. Discuss
Railways problems
Search Results
Correct Answer: 1 in
B.G. and, in 12 M.G. Correct Answer: D (4R - 2G - D)
Correct Answer: pusher gradient
Correct Answer: All the above.
Correct Answer: 3°
Correct Answer: all the above.
Correct Answer: contangent of angle of crossing.
Correct Answer: all the above.
Correct Answer: All the above.
Correct Answer: all the above.
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.