Discussion
Home ‣ Civil Engineering ‣ Railways Comments
- Question
Ballast packed below and around the sleepers to transfer the load from sleepers to formation, generally consists of
Options- A. broken stones
- B. gravels
- C. moorum
- D. all the above.
- Correct Answer
- all the above.
- 1. Minimum packing space provided between two sleepers, is between
Options- A. 20 to 25 cm
- B. 25 to 30 cm
- C. 30 to 35 cm
- D. 35 to 40 cm Discuss
- 2. Top surface of steel sleepers, is
Options- A. kept level throughout
- B. provided a cant of 1 in 20 inward
- C. provided a cant of 1 in 20 outward
- D. none of these. Discuss
- 3. A triangle used for turning the face of locomotives, consists of
Options- A. three turn outs
- B. one turn out and two splits
- C. two turn outs and one split
- D. three splits. Discuss
- 4. To achieve best performance, the type of switch preferred to, is
Options- A. undercut switch
- B. straight-cut switch
- C. overriding switch
- D. both (a) and (b)
- E. none of these. Discuss
- 5. Heel divergency, the distance between the running faces of stock rail and gauge face of tongue rail, as recommended for Indian B.G. tracks, is
Options- A. 100 mm
- B. 119 mm
- C. 125 mm
- D. 155 mm
- E. 135 mm Discuss
- 6. Type of switch rails generally adopted for modern track, is
Options- A. straight switch
- B. curved switch
- C. loose heel switch
- D. bent switch. Discuss
- 7. Gauge of a permanent way, is
Options- A. minimum distance between running faces of rails
- B. minimum distance between outer faces of rails
- C. distance between centres of rails
- D. width of formation
- E. none of these. Discuss
- 8. If S is cant deficiency in centimetres and V is maximum permissible speed in km p.h,, the maximum length of transition curves, is
Options- A.
- B.
- C.
- D.
Discuss
- 9. Pot sleepers are used if degree of the curve does not exceed
Options- A. 4°
- B. 5°
- C. 6°
- D. 7°
- E. 8° Discuss
- 10. If D is the distance between the parallel sidings and ? is the angle of crossing, the distance between the noses of crossing measured parallel to the gathering line, is
Options- A. D tan ?
- B. D cot ?
- C. D sin ?
- D. D cos ? Discuss
Railways problems
Search Results
Correct Answer: 30 to 35 cm
Correct Answer: provided a cant of 1 in 20 inward
Correct Answer: two turn outs and one split
Correct Answer: overriding switch
Correct Answer: 135 mm
Correct Answer: curved switch
Correct Answer: minimum distance between running faces of rails
Correct Answer:
Correct Answer: 4°
Correct Answer: D cot ?
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.