logo

CuriousTab

CuriousTab

Discussion

Home ‣ Civil Engineering ‣ Railways Comments
  • Question

  • Heel of crossing is the line joining


  • Options
  • A. ends of splice rail and point rail
  • B. ends of lead rails butting the crossing
  • C. ends of wing rails
  • D. throat and actual nose of crossing.

  • Correct Answer
  • ends of splice rail and point rail 

    • Railways problems

    Search Results

    • 1. Minimum length of a transition curve required for

    • Options
    • A. 2° curves for a maximum permissible speed of 135 km/hr, is 220 metres
    • B. 4° curves for a maximum permissible speed of 95 km/hr, is 220 metres
    • C. 6° curves for a maximum permissible speed of 80 km/hr, is 220 metres
    • D. All the above.
      • Discuss
    • 2. Regional Indian railways use different types of sleepers according to their

    • Options
    • A. availability
    • B. economy
    • C. suitability
    • D. design
    • E. all the above.
      • Discuss
    • 3. Coning of wheels is provided

    • Options
    • A. to check lateral movement of wheels
    • B. to avoid damage to inner faces of rails
    • C. to avoid discomfort to passengers
    • D. All the above.
      • Discuss
    • 4. According to Railway Board, no diamond crossing should be flatter than

    • Options
    • A. 1 in 6
    • B. 1 in
    • C. 1 in 12
    • D. 1 in 16
      • Discuss
    • 5. The field capacity of a soil depends upon

    • Options
    • A. capillary tension in soil
    • B. porosity of soil
    • C. both (a) and (b)
    • D. neither (a) nor (b).
      • Discuss
    • 6. The spread between the point and splice rails at a distance of 4.25 rn is 50 cm. The size of the crossing is

    • Options
    • A. 1 in 6
    • B. 1 in
    • C. 1 in 12
    • D. 1 in 16
      • Discuss
    • 7. By interchanging gibs and cotters of a pot sleeper, gauge may be slackened by

    • Options
    • A. 1.2 mm
    • B. 2.2 mm
    • C. 3.2 mm
    • D. 4.2 mm
    • E. 5.0 mm
      • Discuss
    • 8. A mono-block sleeper has

    • Options
    • A. square section
    • B. rectangular section
    • C. trapezoidal section
    • D. semi-circular section
    • E. none of these.
      • Discuss
    • 9. For providing the required tilt of rails, adazing of wooden sleepers, is done for

    • Options
    • A. bull headed rails
    • B. double headed rails
    • C. flat footed rails
    • D. any type of rails
    • E. none of these.
      • Discuss
    • 10. The standard dimensions of a wooden sleeper for M.G. railway track are

    • Options
    • A. 2.74 m x 25 cm x 13 cm
    • B. 1.83 m x 20 cm x 11 cm
    • C. 1.52 m x 15 cm x 10 cm
    • D. 1.75 m x 20 cm x 12 cm
    • E. none of these.
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.