logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Waste Water Engineering Comments

  • Question
  • For design of sewers, percentage of sewage discharge is assumed


  • Options
  • A. 65 to 70%
  • B. 70 to 75%
  • C. 75 to 80%
  • D. 85%.

  • Correct Answer
  • 75 to 80% 


  • Waste Water Engineering problems


    Search Results


    • 1. The gas evolved in sewers is

    • Options
    • A. Carbondioxide
    • B. Hydrogen sulphide
    • C. Methane
    • D. All of these.
    • Discuss
    • 2. The sewerage system originates from

    • Options
    • A. house sewers
    • B. lateral sewers
    • C. branch sewers
    • D. main sewers
    • E. out fall sewers.
    • Discuss
    • 3. A well oxidized sewage contains nitrogen mainly as

    • Options
    • A. nitrates
    • B. nitrites
    • C. free ammonia
    • D. none of these.
    • Discuss
    • 4. During putrifaction process of sewage the gas given off, is

    • Options
    • A. carbon dioxide
    • B. hydrogen
    • C. ammonia
    • D. methane
    • E. all the above.
    • Discuss
    • 5. The angle subtended by the surface of sewer water with partial flow, at sewer centre is 120°, the depth of sewerage is

    • Options
    • A. 20 cm
    • B. 25 cm
    • C. 40 cm
    • D. 50 cm
    • E. 60 cm.
    • Discuss
    • 6. For a peak discharge of 0.0157 cumec, with a velocity of 0.9 m/sec, the diameter of the sewer main, is

    • Options
    • A. 10 cm
    • B. 12 cm
    • C. 15 cm
    • D. 18 cm
    • E. 20 cm.
    • Discuss
    • 7. A circular sewer section is preferred to because

    • Options
    • A. it is cheaper in construction
    • B. it provides maximum area for a given perimeter
    • C. it provides maximum hydraulic mean depth
    • D. all the above.
    • Discuss
    • 8. The sewer which transports the sewage to the point of treatment, is called

    • Options
    • A. house sewer
    • B. out-fall sewer
    • C. branch sewer
    • D. lateral
    • E. main sewer.
    • Discuss
    • 9. The porosity of sediments in sewer pipes, is usually taken as

    • Options
    • A. 0.010
    • B. 0.011
    • C. 0.012
    • D. 0.013
    • E. 0.020
    • Discuss
    • 10. You are asked to design sewer pipes of diameters 0.4 m to 0.9 m at maximum flow, you will assume the sewer flow running at

    • Options
    • A. full depth
    • B. half full
    • C. two third full
    • D. three fourth full.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment