logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Waste Water Engineering See What Others Are Saying!
  • Question
  • The sewer which received discharge from two or more main sewers, is known as


  • Options
  • A. a trunk sewer
  • B. an outfall sewer
  • C. a main sewer
  • D. an intercepting sewer.

  • Correct Answer
  • a trunk sewer 


  • More questions

    • 1. If two forces acting at a joint are not along the straight line, then for the equilibrium of the joint

    • Options
    • A. one of the forces must be zero
    • B. each force must be zero
    • C. forces must be equal and of the same sign
    • D. forces must be equal in magnitude but opposite in sign.
    • Discuss
    • 2. Chain surveying is well adopted for

    • Options
    • A. small areas in open ground
    • B. small areas with crowded details
    • C. large areas with simple details
    • D. large areas with difficult details.
    • Discuss
    • 3. The polaris remains below horizon at

    • Options
    • A. 10° N
    • B. 50° N Latitude
    • C. equator
    • D. 5° S latitude.
    • Discuss
    • 4. The longitudinal section of the surface of bubble tube is

    • Options
    • A. straight
    • B. circular
    • C. parabolic
    • D. elliptic.
    • Discuss
    • 5. Surcharge storage zone of a reservoir, is

    • Options
    • A. below dead storage
    • B. between dead storage and useful storage
    • C. above useful storage
    • D. also known as valley storage.
    • Discuss
    • 6. C.R.R.I. charts are used to obtain a relatioship between strength of concrete and

    • Options
    • A. water cement ratio
    • B. workability
    • C. grading of aggregate
    • D. fineness modulus
    • E. none of these.
    • Discuss
    • 7. Process of meandering is due to

    • Options
    • A. sediment load of streams
    • B. discharge and hydraulic properties of streams
    • C. relative erodibility of the bed and banks
    • D. all the above.
    • Discuss
    • 8. A soil having particles of nearly the same size is known as

    • Options
    • A. well graded
    • B. uniformly graded
    • C. poorly graded
    • D. gap graded
    • Discuss
    • 9. Four reinforcing bars of 30 mm diameter each, are bundled in contact. The lower two bars extend up to end supports. The distance between the points of termination of the upper bars, is kept

    • Options
    • A. zero
    • B. 1.2 m
    • C. 0.9 m
    • D. 0.75 m
    • Discuss
    • 10. In a simply supported slab, alternate bars are curtailed at

    • Options
    • A. 1/4th of the span
    • B. 1/5th of the span
    • C. 1/6th of the span
    • D. 1/7th of the span
    • E. none of these.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment