logo

CuriousTab

CuriousTab

Discussion

Home ‣ Civil Engineering ‣ Hydraulics Comments
  • Question

  • To ensure that water does not rise more than 100 cm above the crest, for a discharge of 5.00 m3/sec, the length of water will be


  • Options
  • A. 2.48 m
  • B. 2.49 m
  • C. 2.50 m
  • D. 2.51 m.

  • Correct Answer
  • 2.49 m 

    • Hydraulics problems

    Search Results

    • 1. The discharge through an internal mouth piece is more if its length is

    • Options
    • A. < diameter
    • B. < diameter
    • C. ? diameter
    • D. none of these.
      • Discuss
    • 2. The velocity of flow (v) at the outlet of a syphon of length l, is given by

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 3. If a pitot tube is placed with its nose facing down stream, the liquid

    • Options
    • A. does not rise in the tube
    • B. rises in the tube to a height
    • C. falls in the tube to a depth
    • D. none of these.
      • Discuss
    • 4. The formula Q = m x L x 2g x H3/2 where was suggested by :

    • Options
    • A. Bazin
    • B. Francis
    • C. Cipolletti
    • D. None of these.
      • Discuss
    • 5. Chezy's formula is used to determine

    • Options
    • A. head loss due to friction in pipe
    • B. velocity of flow in pipe
    • C. velocity of flow in open channels
    • D. none of these.
      • Discuss
    • 6. Pick up the correct statement regarding convergent divergent mouth piece from the following :

    • Options
    • A. It converges upto Venacontracta and then diverges
    • B. In this mouth piece there is no loss of energy due to sudden enlargement
    • C. The coefficient of discharge is unity
    • D. All the above.
      • Discuss
    • 7. The flow in open channel is said to be critical if the Froude number is :

    • Options
    • A. less than 1.0
    • B. equal to 1.0
    • C. greater than 1.0
    • D. None of these.
      • Discuss
    • 8. The ratio of the maximum height to which a jet inclined through ? rises to its total horizontal span is

    • Options
    • A. sin ?
    • B. cos ?
    • C. tan ?
    • D. cot ?.
      • Discuss
    • 9. To measure very low pressure, we use

    • Options
    • A. barometers
    • B. piezometers
    • C. manometers
    • D. differential manometers.
      • Discuss
    • 10. For uniform flow in canals

    • Options
    • A. there is a balance between the frictional loss and drop in elevation of the channel
    • B. bed and free water surfaces of a channel are parallel to each other
    • C. bed of channel represents the hydraulic gradient
    • D. all the above.
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.