The ratio of the hydraulic radius of a pipe running full to the hydraulic radius

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Civil Engineering ‣ Hydraulics Comments

Question
The ratio of the hydraulic radius of a pipe running full to the hydraulic radius of a square section of a channel whose side is equal to the diameter of the pipe, is
Options
A. 1
B.
C.
D.

Correct Answer

Hydraulics problems

Search Results

1. The initial difference between liquid levels of two identical cylindrical vessels having their area of cross-section A, is H. Flow time T from one vessel to another through an orifice having coefficient of discharge C_d and area a will be
Options
A.
B.
C.
D.

3. In an inclined pipe, the pressure difference at its two ends is due to
Options
A. sudden head drop at inlet
B. exit head drop
C. frictional loss head
D. elevation head
E. all the above.

5. The pressure rise due to water hammer depends upon
Options
A. the velocity of flow of water in the pipe
B. the length of pipe
C. time taken to close the valve
D. the elasticity of the pipe material
E. All of above.

6. Most economical section of a circular channel for maximum velocity, is if,
Options
A. depth of water = 0.810 diameter
B. hydraulic mean depth = 0.304 diameter
C. wetted perimeter = 2.245 diameters
D. all the above.

7. If E₁ and E₂ are the specific energies at the start of back water curve and at the maximum rise of water respectively and ib and ie are the head slope and the energy line slope respectively, the length of back water (L) is given by
Options
A.
B.
C.
D. None of these.

10. Pick up the incorrect statement from to following regarding triangular notch :
Options
A. For measuring low discharge, it gives more accurate result
B. Only one reading (i.e. H) is required for computation of discharge
C. Ventilation is necessary
D. None of these.

Comments

More in Civil Engineering: