Discussion
Home ‣ Civil Engineering ‣ Hydraulics Comments
- Question
Dimensions of the dynamic viscosity (?) are
Options- A. MLT-2
- B. M-1L-1T-1
- C. ML-1T-2
- D. ML-1T-1.
- Correct Answer
- ML-1T-1.
- 1. Most economical section of a triangular channel, is
Options- A. equilateral triangle
- B. right angled triangle
- C. isosceles triangle with 45° vertex angle
- D. right angled triangle with equal sides. Discuss
- 2. The ratio of frictional factor and coefficient of friction used in general equation for a head loss in a pipe, is
Options- A. 1
- B. 2
- C. 3
- D. 4 Discuss
- 3. When no air is left below the nappe and water stream adheres to the down stream face of the weir, it is known as
Options- A. free nappe
- B. depressed nappe
- C. clinging nappe
- D. none of these. Discuss
- 4. The rise of the liquid along the walls of a revolving cylinder above the initial level, is
Options- A. greater than the depression of the liquid at the axis of rotation
- B. lesser than the depression of the liquid at the axis of rotation
- C. the same as the depression of the liquid at the axis of rotation
- D. none of these. Discuss
- 5. Piezometers are used to measure
Options- A. pressure in water channels, pipes etc.
- B. difference in pressure at two points
- C. atmospheric pressure
- D. very low pressure. Discuss
- 6. In Chezy's formula V = C mi
Options- A. V is the mean velocity of flow
- B. m is the hydraulic mean depth
- C. i is the loss of head per unit length of pipe
- D. All the above. Discuss
- 7. Power transmitted through a pipe is maximum when friction head loss, is
Options- A. one-half of the total head supplied
- B. one-third of the total head supplied
- C. one-fouth of the total head supplied
- D. equal to the total head supplied. Discuss
- 8. Specific weight of liquid
Options- A. remains constant at every place
- B. does not remain constant at every place
- C. varies from place to place on the earth
- D. does not vary on any other planet. Discuss
- 9. Cappoletti weir is a
Options- A. rectangular weir whose length is kept 3 times the height of the water above sill
- B. triangular weir whose notch angle is 90°
- C. trapezoidal weir, whose sides slope 1 horizontal to 2 verticals
- D. a combination of rectangular and triangular weirs. Discuss
- 10. Fluids change the volume under external presssure due to
Options- A. plasticity
- B. viscosity
- C. compressibility
- D. none of these. Discuss
Hydraulics problems
Search Results
Correct Answer: right angled triangle with equal sides.
Correct Answer: 4
Correct Answer: clinging nappe
Correct Answer: the same as the depression of the liquid at the axis of rotation
Correct Answer: very low pressure.
Correct Answer: All the above.
Correct Answer: one-third of the total head supplied
Correct Answer: does not vary on any other planet.
Correct Answer: trapezoidal weir, whose sides slope 1 horizontal to 2 verticals
Correct Answer: compressibility
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.