Discussion
Home ‣ Civil Engineering ‣ Hydraulics Comments
- Question
A steady uniform flow is through
Options- A. a long pipe at decreasing rate
- B. a long pipe at constant rate
- C. an expanding tube at constant rate
- D. an expanding tube at increasing rate
- E. a long pipe at increasing rate.
- Correct Answer
- a long pipe at constant rate
- 1. Cavitation is caused by
Options- A. Low pressure
- B. High pressure
- C. Low velocity
- D. High velocity
- E. None of these. Discuss
- 2. Hydraulic gradient is equal to difference in water surfaces
Options- A.
- B.
- C.
- D.
Discuss
- 3. The discharge over a Cipolletti weir of length 2.185 m when the head over the weir is 1 m, is
Options- A. 2.0 m3
- B. 2.5 m3
- C. 3.0 m3
- D. 4.0 m3. Discuss
- 4. For critical depth of flow of water in open channels, fc the specific energy must be :
Options- A. minimum
- B. maximum
- C. average of maximum and minimum
- D. None of these. Discuss
- 5. In a centrifugual pump casing, the flow of water leaving the impeller, is
Options- A. rectilinear flow
- B. radial flow
- C. free vortex motion
- D. forced vertex. Discuss
- 6. Gauge pressure is
Options- A. absolute pressure - atmospheric pressure
- B. absolute pressure + atmospheric pressure
- C. atmospheric pressure - absolute pressure
- D. none of these. Discuss
- 7. The height of water level in a tank above the centre of a circular hole 2.5 cm in diameter is 50 m. The velocity of water flowing through the hole, is
Options- A. 31.1 m/sec
- B. 31.2 m/sec
- C. 31.3 m/sec
- D. 31.4 m/sec. Discuss
- 8. In order to avoid capillary correction, the minimum diameter of a manometer used for measuring pressure, should be
Options- A. 2 mm
- B. 4 mm
- C. 6 mm
- D. 8 mm
- E. 10 mm. Discuss
- 9. If cohesion between the molecules of a fluid is more than adhesion between the fluid and glass, the free level of fluid in a dipped glass tube will be
Options- A. higher than the surface of liquid
- B. same as the surface of liquid
- C. lower than the surface of liquid
- D. none of these. Discuss
- 10. Euler's equation for the motion of liquids assumes that
Options- A. fluid is viscous
- B. fluid is homogeneous and incompressible
- C. velocity of flow is non-uniform over the section
- D. flow is unsteady along the stream line. Discuss
Hydraulics problems
Search Results
Correct Answer: Low pressure
Correct Answer:
Correct Answer: 4.0 m3.
Correct Answer: minimum
Correct Answer: free vortex motion
Correct Answer: absolute pressure - atmospheric pressure
Correct Answer: 31.3 m/sec
Correct Answer: 6 mm
Correct Answer: lower than the surface of liquid
Correct Answer: fluid is homogeneous and incompressible
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.