logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Hydraulics Comments

  • Question
  • The valve closure is said to be sudden if


  • Options
  • A. The valve closure is said to be sudden if
  • B. The valve closure is said to be sudden if
  • C. The valve closure is said to be sudden if
  • D. The valve closure is said to be sudden if

  • Correct Answer
  •  


  • Hydraulics problems


    Search Results


    • 1. The terminal velocity (v) of a sphere of radius r and specific weight W, which travels vertically downwards in a liquid of viscosity ? and specific weight W, is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 2. The main assumption of Bernoulli's equation is :

    • Options
    • A. The velocity of energy of liquid particle, across any cross-section of a pipe is uniform
    • B. No external force except the gravity acts on the liquid
    • C. There is no loss of energy of the liquid while flowing
    • D. All the above.
    • Discuss
    • 3. Due to decrease of diameter of the droplet, inside pressure intensity

    • Options
    • A. increases
    • B. decreases
    • C. remains unaffected
    • D. None of these.
    • Discuss
    • 4. The velocity of the fluid particle at the centre of the pipe section, is

    • Options
    • A. minimum
    • B. maximum
    • C. equal throughout
    • D. none of these.
    • Discuss
    • 5. On a ladder resting on a rough ground and leaning against a smooth vertical wall, the force of friction acts

    • Options
    • A. downwards at its upper end
    • B. upwards at its upper end
    • C. perpendicular to the wall at its upper end
    • D. zero at its upper end
    • E. none of these.
    • Discuss
    • 6. The ratio of the inertia and gravitational force acting in any flow, ignoring other forces, is called

    • Options
    • A. Euler number
    • B. Frode number
    • C. Reynold number
    • D. Weber number.
    • Discuss
    • 7. A rectangular channel 6 m wide and 3 m deep and having a bed slope as 1 in 2000 is running full. If Chezy's constant C = 54.8, pick up the correct specification of the channel from the following :

    • Options
    • A. hydraulic mean depth = 1.5 m
    • B. Velocity of flow = 1.5 m/sec
    • C. Rate of flow = 27 m3/sec
    • D. All the above.
    • Discuss
    • 8. For most economical rectangular section of a channel, the depth is kept

    • Options
    • A. one-fourth of the width
    • B. three times the hydraulic radius
    • C. half the width
    • D. hydraulic mean depth
    • E. none of these.
    • Discuss
    • 9. Hydraulic ram is a device

    • Options
    • A. for lifting water without an electric motor
    • B. for accelerating water flow
    • C. for lifting heavy loads
    • D. none of these.
    • Discuss
    • 10. When water flows over a rectangular suppressed weir, the negative pressure created beneath the nappe

    • Options
    • A. increases the discharge
    • B. decreases the discharge
    • C. does not effect the discharge
    • D. none of these.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment