logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Applied Mechanics See What Others Are Saying!
  • Question
  • A glass ball is shot to hit a wall from a point on a smooth floor. If the ball returns back to the point of projection in twice the time taken in reaching the wall, the coefficient of restitution between the glass ball and the wall is


  • Options
  • A. 0.25
  • B. 0.33
  • C. 0.40
  • D. 0.50
  • E. 0.55

  • Correct Answer
  • 0.50 


  • More questions

    • 1. If the width of a simply supported beam carrying an isolated load at its centre is doubled, the deflection of the beam at the centre is changed by

    • Options
    • A. 1/2
    • B. 1/8
    • C. 2
    • D. 8
    • E. 4
    • Discuss
    • 2. Electromagnetic spectrum contains :

    • Options
    • A. gamma rays (wave length < 10-10 m)
    • B. ultraviolet rays (wave length < 10-6 m)
    • C. infrared rays (wave length < 10-4 m)
    • D. radio rays (wave length > 1 m)
    • E. All of these
    • Discuss
    • 3. The diaphragm of a stadia theodolite is fitted with two additional

    • Options
    • A. horizontal hairs
    • B. vertical hairs
    • C. horizontal and two vertical hairs
    • D. none of these.
    • Discuss
    • 4. Modified moment of inertia of sections with a single web, is equal to moment of inertia of the section about Y-Y axis at the point of maximum bending moment and is multiplied by the ratio of

    • Options
    • A. area of compression flange at the minimum bending moment to the corresponding area at the point of maximum bending moment
    • B. area of tension flange at the minimum bending moment of the corresponding area at the point of maximum bending moment
    • C. total area of flanges at the maximum bending moment to the corresponding area at the point of maximum bending moment
    • D. none of these.
    • Discuss
    • 5. Pick up the correct statement from the following:

    • Options
    • A. Runway edge from the landing side, is called threshold
    • B. Localizer indicates to the pilot his position with respect to the proposed alignment
    • C. The glide slope indicates the correct angle of descent
    • D. L.O.M. and L.M.M. help the pilot to judge his position for the runway
    • E. All the above.
    • Discuss
    • 6. The maximum energy stored at elastic limit of a material is called

    • Options
    • A. resilience
    • B. proof resilience
    • C. modulus of resilience
    • D. bulk resilience
    • Discuss
    • 7. The ratio of frictional factor and coefficient of friction used in general equation for a head loss in a pipe, is

    • Options
    • A. 1
    • B. 2
    • C. 3
    • D. 4
    • Discuss
    • 8. An aggregate is known as cyclopean aggregate if its size is more than

    • Options
    • A. 4.75 mm
    • B. 30 mm
    • C. 60 mm
    • D. 75 mm
    • E. 90 mm.
    • Discuss
    • 9. Pick up the correct statement from the following

    • Options
    • A. Approach of the water line in a flumed channel section should not be steeper than
    • B. Departure of the water line from a flumed channel section should not be steeper than 30°
    • C. Approach of the water line should not be steeper than 30° and departure line not steeper than in a flumed channel section
    • D. Approach and departure of the water line in a flumed channel section, should not be steeper than
    • Discuss
    • 10. Minimum permissible speed on high speed roads, is decided on the basis of

    • Options
    • A. 15 percentile cumulative frequency
    • B. 20 percentile cumulative frequency
    • C. 30 percentile cumulative frequency
    • D. 40 percentile cumulative frequency.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment