logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Applied Mechanics See What Others Are Saying!
  • Question
  • For the system of the loads shown in below figure, the time required for the 6.6 kg load to fall on the edge, is
    For the system of the loads shown in below figure, the time required for the 6.6 kg load to fall on


  • Options
  • A. 1 sec.
  • B. 2 sec.
  • C. 3 sec.
  • D. 4 sec.
  • E. 5 sec.

  • Correct Answer
  • 3 sec. 


  • More questions

    • 1. For road pavements, the cement generally used, is

    • Options
    • A. ordinary Portland cement
    • B. rapid hardening cement
    • C. low heat cement
    • D. blast furnace slag cement
    • E. none of these.
    • Discuss
    • 2. In stone masonry, stones (stratified rocks) are so placed that the direction of pressure to the plane of bedding is

    • Options
    • A. right angles
    • B. 45°
    • C. 60°
    • D. parallel
    • E. None of these.
    • Discuss
    • 3. The total area of side face reinforcement, in case of a deep beam should not be less than

    • Options
    • A. 0.1% of web area
    • B. 0.2% of web area
    • C. 0.3% of web area
    • D. 0.4% of web area.
    • Discuss
    • 4. Most commonly used section in grade aqueducts, is

    • Options
    • A. circular
    • B. rectangular
    • C. parabolic
    • D. horse shoe section.
    • Discuss
    • 5. For trunk sewers more than 1.25 m in diameter, the ratio of the maximum daily sewage flow to the average daily sewage flow is assumed

    • Options
    • A. 1.5
    • B. 2.0
    • C. 2.5
    • D. 3.0
    • E. 3.5
    • Discuss
    • 6. An angle of deflection right, may be directly obtained by setting the instrument to read

    • Options
    • A. zero on back station
    • B. 180° on back station
    • C. 90°
    • D. 270° on back station.
    • Discuss
    • 7. Pick up the incorrect statement from the following:

    • Options
    • A. Lead is the average horizontal straight distance between the borrow pit and the place of spreading soil
    • B. The lead is calculated for each block of the excavated area
    • C. The unit of lead is 50 m for a distance upto 500 m
    • D. The unit of lead is 1 km where the lead exceeds 2 km.
    • Discuss
    • 8. The bearing of C from A is N 30° E and from B, 50 metres east of A, is N 60° W. The departure of C from A is

    • Options
    • A. 50 m
    • B. 50 3 m
    • C. 25 3 m
    • D. 25 m
    • Discuss
    • 9. The heaviest line is used to democrate

    • Options
    • A. the low water line
    • B. the high water line
    • C. the limit of swamps
    • D. the direction of current.
    • Discuss
    • 10. Pick up the correct statement from the following:

    • Options
    • A. The artificial barrier constructed to enclose "n area for safe anchorage, is called break water
    • B. The smoothened surface at the top end of the vertical face of a guay wall, is called fending
    • C. The effective berthing lengths of inclined guays can be adjusted
    • D. All the above.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment