logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Soil Mechanics and Foundation Engineering Comments

  • Question
  • The general relationship between specific gravity (G), weight of water (??), degree of saturation ( S r ), void ratio (e) and bulk density (?), is


  • Options
  • A. ? = The general relationship between specific gravity (G), weight of water (??), degree of saturation (
  • B. ? = The general relationship between specific gravity (G), weight of water (??), degree of saturation (
  • C. ? = The general relationship between specific gravity (G), weight of water (??), degree of saturation (
  • D. ? = The general relationship between specific gravity (G), weight of water (??), degree of saturation (

  • Correct Answer
  • ? =  


  • Soil Mechanics and Foundation Engineering problems


    Search Results


    • 1. The critical exist gradient of seepage water in soils, is

    • Options
    • A. directly proportional to the voids ratio
    • B. inversely proportional to the specific gravity
    • C. directly proportional to the specific gravity
    • D. inversely proportional to the voids ratio
    • E. none of these.
    • Discuss
    • 2. The direct shear test suffers from the following disadvantage:

    • Options
    • A. Drain condition cannot be controlled
    • B. Pore water pressure cannot be measured
    • C. Shear stress on the failure plane is not uniform.
    • D. The area under the shear and vertical loads does not remain constant throughout the test
    • E. All the above.
    • Discuss
    • 3. If L and B are the length and breadth of a footing, e the eccentricity along the length and P and Q are the axial force and bearing capacity of the soil, then, to avoid tension,

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 4. For determining the moisture content of a soil sample, the following data is available Weight of container = 260 g, Weight of soil sample and = 320 g container, Weight of soil sample (dried) and = 310 g container. The moisture content of the soil sample, is

    • Options
    • A. 15%
    • B. 18%
    • C. 20%
    • D. 25%
    • Discuss
    • 5. If the specific gravity of a soil particle of 0.05 cm diameter is 2.67, its terminal velocity while settling in distilled water of viscosity, 0.01 poise, is

    • Options
    • A. 0.2200 cm/sec
    • B. 0.2225 cm/sec
    • C. 0.2250 cm/sec
    • D. 0.2275 cm/sec
    • E. 0.2300 cm/sec
    • Discuss
    • 6. If C is cohesion, F is factor of safety, ? is unit weight of soil and H is the maximum height of embankment, the stability number, is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
    • Discuss
    • 7. A phreatic line is defined as the line within a dam section below which there are

    • Options
    • A. positive equipotential lines
    • B. positive hydrostatic pressure
    • C. negative hydrostatic pressure
    • D. negative equipotential lines
    • E. none of these.
    • Discuss
    • 8. The compressibility of clays, is caused due to:

    • Options
    • A. expulsion of double layer water from in between the grains
    • B. sliping of particles to new positions of greater density
    • C. bending of particles as elastic sheets
    • D. all the above.
    • Discuss
    • 9. Pick up the correct statement from the following :

    • Options
    • A. To an agriculturist, soil is the substance existing on the earth's surface, which grows and develops plants
    • B. To a geologist, soil is the material in a relatively thin surface zone within which roots occur, and rest of the crust is termed as rock irrespective of hardness
    • C. To an engineer, soil is the unaggregated and uncemented deposits of minerals and organic particles covering the earth's crust
    • D. All the above.
    • Discuss
    • 10. For determing the specific gravity of soil solids, using a pycnometer of 500 cc., the following data is available : Weight of dry empty pycnometer = 125 g Weight of dried soil and pycnometer = 500 g Weight of dried soil and distilled = 850 g water filled in pycnometer up to top The specific gravity of soil soilds, is

    • Options
    • A. 2.0
    • B. 2.25
    • C. 2.50
    • D. 2.75
    • Discuss


    Comments

    There are no comments.

Enter a new Comment