Discussion
Home ‣ Civil Engineering ‣ Soil Mechanics and Foundation Engineering Comments
- Question
The maximum load carried by a pile, when it continues to sink without further increase of load, is known as
Options- A. ultimate load carrying capacity
- B. ultimate bearing capacity
- C. ultimate bearing resistant
- D. all the above.
- Correct Answer
- all the above.
- 1. Pick up the correct statement from the following:
Options- A. The void space between the soil grains, is filled partly with air and partly with water
- B. In perfectly saturated soil, the voids are completely filled with water
- C. In dry soil, the voids are completely filled with air
- D. all the above. Discuss
- 2. Pick up the incorrect statement from the following:
Options- A. Compaction has no effect on the structure of a soil
- B. Permeability decreases with increase in the dry density of a compacted soil
- C. A wet side compacted soil is more compressible than a dry side compacted soil
- D. Dry side compaction soils swell more when given access to moisture
- E. None of the these. Discuss
- 3. A decrease in water content results in a reduction of the volume of a soil in
Options- A. liquid state
- B. plastic state
- C. semi solid state
- D. all of these. Discuss
- 4. The soil moisture driven off by heat, is called
Options- A. free water
- B. hydroscopic water
- C. gravity water
- D. none of these. Discuss
- 5. Pick up the correct statement from the following:
Options- A. If the ratio of depth to width is less than 2, it is shallow foundation
- B. If the ratio of depth to width is more than 2, it is deep foundation
- C. If the ratio of the length to width is between 1 and 2, it is spread foundation
- D. If the length is large as compared to width, it is a strip foundation
- E. All the above. Discuss
- 6. The maximum shear stress occurs on the filament which makes an angle with the horizontal plane equal to
Options- A. 30°
- B. 45°
- C. 60°
- D. 90° Discuss
- 7. Water content of a soil sample is the difference of the weight of the given sample at the given temperature and the weight determined after drying it for 24 hours at temperature ranging from
Options- A. 80° to 90°C
- B. 90° to 95°C
- C. 95° to 100°C
- D. 103° to 105°C
- E. 105° to 110°C Discuss
- 8. If ?0' and ?' represent initial and increased pressure ; e0 and e void ratios corresponding to initial and increased pressure ; and C0 the compression index (dimensionless), then, the virgin compression curve as expressed by Terzaghi empirical formula is
Options- A. e = e0 + Cc log10 ?'/?0'
- B. e = e0 - Cc log10 ?'/?0'
- C. e0 = e - Cc log10 ?'/?0'
- D. e0 = e + Cc log10 ?0'/?' Discuss
- 9. The soil which contains finest grain particles, is
Options- A. coarse sand
- B. fine sand
- C. silt
- D. clay. Discuss
- 10. According to the Indian Standards the specific gravity is the ratio of the unit weight of soil solids to that of water at a temperature of
Options- A. 17°C
- B. 23°C
- C. 27°C
- D. 30° Discuss
Soil Mechanics and Foundation Engineering problems
Search Results
Correct Answer: all the above.
Correct Answer: Compaction has no effect on the structure of a soil
Correct Answer: all of these.
Correct Answer: hydroscopic water
Correct Answer: All the above.
Correct Answer: 45°
Correct Answer: 105° to 110°C
Correct Answer: e = e0 - Cc log10 ?'/?0'
Correct Answer: clay.
Correct Answer: 27°C
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.