Discussion
Home ‣ Civil Engineering ‣ Surveying Comments
- Question
A sewer is laid from a manhole A to a manhole B, 250 m away along a gradient of 1 in 125. If the reduced level of the invert at A is 205.75 m and the height of the boning rod is 3 m, the reduced level of the sight rail at B, is
Options- A. 208.75 m
- B. 202.75 m
- C. 206.75 m
- D. 211.75 m
- Correct Answer
- 206.75 m
- 1. The distance between terminal points computed from a subsidiary traverse run between them, is generally known, as
Options- A. traverse leg
- B. a base
- C. traverse base
- D. all the above. Discuss
- 2. Check lines (or proof lines) in Chain Surveying, are essentially required
Options- A. to plot the chain lines
- B. to plot the offsets
- C. to indicate the accuracy of the survey work
- D. to increase the out-turn Discuss
- 3. Pick up the correct statement from the following
Options- A. 1 second of arc corresponds to a displacement ratio of 1:206, 300
- B. 1 degree of arc corresponds to a displacement ratio of 1:57
- C. the angular errors tend to propagate themselves along a traverse as the square root of the number of stations
- D. the errors arising from the linear measures tend to be roughly proportional to the lengths of the lines
- E. all the above. Discuss
- 4. The operation of resection involves the following steps
- rough orientation of the plane table
- the three lines form a triangle of error
- drawing lines back through the three control points
- select a point in the triangle of error such that each ray is equally rotated either clockwise or anti clockwise
- the points obtained by three rays is the correct location.
The correct sequence is
Options- A. 1, 3, 2, 4, 5
- B. 1, 2, 3, 4, 5
- C. 1, 4, 3, 2, 5
- D. 1, 4, 2, 3, 5 Discuss
- 5. If a linear traverse follows a sharp curve round a large lake where it is difficult to have long legs, the accuracy of the traverse may be improved by
Options- A. taking short legs
- B. making repeated observations of angular and linear measurements
- C. making a subsidiary traverse to determine the length of a long leg
- D. all the above. Discuss
- 6. For locating a distant object visible from two transit stations, the method usually preferred to, is
Options- A. Angles and distances from transit stations
- B. Angles from two transit stations
- C. distance from two transit stations
- D. Angle from one transit station and distance from the other. Discuss
- 7. Chain surveying is well adopted for
Options- A. small areas in open ground
- B. small areas with crowded details
- C. large areas with simple details
- D. large areas with difficult details. Discuss
- 8. The line of collimation method of reduction of levels, does not provide a check on
Options- A. intermediate sights
- B. fore sights
- C. back sights
- D. reduced levels. Discuss
- 9. Short offsets are measured with
Options- A. an ordinary chain
- B. an invar tape
- C. a metallic tape
- D. a steel tape. Discuss
- 10. The approximate formula for radial or perpendicular offsets from the tangent, is
Options- A.
- B.
- C.
- D.
Discuss
Surveying problems
Search Results
Correct Answer: traverse base
Correct Answer: to indicate the accuracy of the survey work
Correct Answer: all the above.
Correct Answer: 1, 3, 2, 4, 5
Correct Answer: making a subsidiary traverse to determine the length of a long leg
Correct Answer: Angles from two transit stations
Correct Answer: small areas in open ground
Correct Answer: intermediate sights
Correct Answer: an ordinary chain
Correct Answer:
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.