Discussion
Home ‣ Civil Engineering ‣ Surveying Comments
- Question
Systematic errors are those errors
Options- A. which cannot be recognised
- B. whose character is understood
- C. whose effects are cumulative and can be eliminated
- D. none of these.
- Correct Answer
- whose effects are cumulative and can be eliminated
- 1. The bearings of two traverse legs AB and BC are N52° 45' E and N34° 30' E respectively. The deflection angle is
Options- A. 18° 15' E
- B. 18° 15' N
- C. 18° 15' W
- D. 18° 15' R
- E. 18° 15' L Discuss
- 2. Magnetic declination at any place
Options- A. remains constant
- B. does not remain constant
- C. fluctuates
- D. changes abruptly. Discuss
- 3. The zero of the graduated circle of a prismatic compass is located at
Options- A. north end
- B. east end
- C. south end
- D. west end. Discuss
- 4. A standard steel tape of length 30 m and cross-section 15 x 1.0 mm was standardised at 25°C and at 30 kg pull. While measuring a base line at the same temperature, the pull applied was 40 kg. If the modulus of elasticity of steel tape is 2.2 x 106 kg/cm2, the correction to be applied is
Options- A. - 0.000909 m
- B. + 0.0909 m
- C. 0.000909 m
- D. none of these Discuss
- 5. If L is in kilometres, the curvature correction is
Options- A. 58.2 L2 mm
- B. 64.8 L2 mm
- C. 74.8 L2 mm
- D. 78.4 L2 mm. Discuss
- 6. Greater accuracy in linear measurements, is obtained by
Options- A. tacheometry
- B. direct chaining
- C. direct taping
- D. all the above. Discuss
- 7. From any point on the surface with a given inclination
Options- A. only one contour gradient is possible
- B. two contour gradients are possible
- C. indefinite contour gradients are possible
- D. all the above. Discuss
- 8. Which of the following introduces an error of about 1 in 1000 if 20 m chain is used
Options- A. length of chain 20 mm wrong
- B. one end of the chain 0.9 m off the line
- C. one end of chain 0.9 m higher than the other
- D. middle of the chain 0.45 m off the line
- E. all the above. Discuss
- 9. Total latitude of a point is positive if it lies
Options- A. north of the reference parallel
- B. south of the reference parallel
- C. east of the reference parallel
- D. west of the reference parallel. Discuss
- 10. Perpendicularity of an offset may be judged by eye, if the length of the offset is
Options- A. 5 m
- B. 10 m
- C. 15 m
- D. 20 m. Discuss
Surveying problems
Search Results
Correct Answer: 18° 15' L
Correct Answer: does not remain constant
Correct Answer: south end
Correct Answer: - 0.000909 m
Correct Answer: 78.4 L2 mm.
Correct Answer: direct taping
Correct Answer: indefinite contour gradients are possible
Correct Answer: all the above.
Correct Answer: north of the reference parallel
Correct Answer: 15 m
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.