Discussion
Home ‣ Chemical Engineering ‣ Process Equipment and Plant Design Comments
- Question
Steam side heat transfer co-efficient for design consideration under ordinary condition can be assumed to be about __________ kcal/hr.m2.°C.
Options- A. 1250
- B. 2500
- C. 7500
- D. 15000
- Correct Answer
- 7500
- 1. The value of fouling factor depends upon the
Options- A. characteristic of process fluid.
- B. velocity of process fluid containing suspended solids.
- C. suspended solids in the fluid.
- D. all (a), (b) and (c). Discuss
- 2. To keep the power input constant for a stirred vessel operating under fully developed turbulent flow conditions (constant power number), if the impeller diameter is increased by 20%, the impeller speed should be decreased by a factor of
Options- A. (1.2)3/2
- B. (1.2)3/5
- C. (1.2)2/3
- D. (1.2)5/3 Discuss
- 3. Pressure drop (?p) and the superficial gas mass velocity (G) in case of packed absorption tower operating in the preloading range are related as
Options- A. ?p = G
- B. ?p = G0.5
- C. ?p = G2
- D.
Discuss
- 4. The main purpose of providing stepping on the trays is to
Options- A. increase the residence time.
- B. decrease the pressure drop.
- C. facilitate handling of large flow rate of liquid.
- D. improve the flow condition. Discuss
- 5. The stress developed in a material without any permanent set is called the
Options- A. ultimate stress
- B. yield stress
- C. elastic limit
- D. breaking stress Discuss
- 6. __________ tray arrangement is recommended for distillation column having diameter upto 4 ft.
Options- A. Radial flow
- B. Cross flow
- C. Split flow
- D. Cascade Discuss
- 7. In case of a shell and tube heat exchanger, the minimum shell thickness for carbon steel (inclusive of corrosion allowance) depends on shell diameter and is in the range of __________ mm.
Options- A. 3-5
- B. 5-11
- C. 8-15
- D. 12-18 Discuss
- 8. Pick out the wrong statement
Options- A. For all the cylindrical process vessels operating above atmospheric pressure, formed heads are used for closing the vessel.
- B. Fouling factor of river water is less than that of sea water.
- C. Risers provided in bubble cap trays in the distillation column facilitate the flow of both liquid and vapor.
- D. both (b) and (c). Discuss
- 9. In a multipass shell and tube heat exchanger, the shell side cross flow area does not depend upon
Options- A. baffle spacing
- B. clearance
- C. pitch
- D. none of these Discuss
- 10. Which of the following may not need a moderator?
Options- A. Candu reactor
- B. Fast breeder reactor
- C. Homogeneous reactor
- D. Pressurised water reactor Discuss
Process Equipment and Plant Design problems
Search Results
Correct Answer: all (a), (b) and (c).
Correct Answer: (1.2)5/3
Correct Answer: ?p = G2
Correct Answer: facilitate handling of large flow rate of liquid.
Correct Answer: elastic limit
Correct Answer: Cross flow
Correct Answer: 5-11
Correct Answer: both (b) and (c).
Correct Answer: none of these
Correct Answer: Fast breeder reactor
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.