Discussion
Home ‣ Chemical Engineering ‣ Chemical Engineering Basics Comments
- Question
Maxwell's thermodynamic relations applies to the
Options- A. chemical systems in equilibrium.
- B. mechanical systems in equilibrium.
- C. irreversible thermodynamic processes.
- D. reversible thermodynamic processes.
- Correct Answer
- chemical systems in equilibrium.
- 1. If a nuclear reactor produces more fissile nuclear fuel than it consumes, then it is called a __________ reactor.
Options- A. critical
- B. breeder
- C. fertile
- D. heterogenous Discuss
- 2. Machinability of hard alloys and tool steels is improved by
Options- A. spherodising
- B. annealing
- C. tempering
- D. normalising Discuss
- 3. __________ is the hardest oxide and is hence used where high wear resistance at high temperature is required.
Options- A. Beryllia
- B. Zirconia
- C. Alumina
- D. Magnesia Discuss
- 4. Which one of the following is incombustible?
Options- A. H2
- B. CCl4
- C. C2H2
- D. S Discuss
- 5. In condensers used in thermal power plants, steam is normally used in shell side and cooling water on the tube side, because of the reason that
Options- A. compared to the mass flow rate of cooling water, the rate of condensation of steam is invariably smaller.
- B. maintaining vacuum on tube side is more difficult than that on the shell side.
- C. water velocity can be increased conveniently to increase the overall heat transfer co-efficient because of its lower specific volume compared to steam.
- D. condenser can act as a storage unit for condensed steam. Discuss
- 6. Evaporative cooling process employs a combination of cooling and humidification in which the
Options- A. sensible heat is added.
- B. sensible heat is removed and the latent heat is added.
- C. latent heat is removed.
- D. sensible heat is added and latent heat is removed. Discuss
- 7. Corrosion of metals can not be prevented by its
Options- A. tempering
- B. chromising
- C. aluminising
- D. alloying Discuss
- 8. Nusselt number is related to Grashoff number (Gr) in turbulent & laminar flow respectively, in respect of free convection over a vertical flat plate as
Options- A. Gr0.25, Gr
- B. Gr0.25, Gr0.33
- C. Gr, Gr0.25
- D. Gr0.33, Gr0.25 Discuss
- 9. Annealing ofwhite cast iron produces __________ iron.
Options- A. grey
- B. nodular
- C. malleable
- D. spheroidal Discuss
- 10. An alloy of Fe - 0.4 % C is
Options- A. cast iron.
- B. hypo-eutectoid steel.
- C. hyper-eutectoid steel.
- D. eutectoid steel Discuss
Chemical Engineering Basics problems
Search Results
Correct Answer: breeder
Correct Answer: annealing
Correct Answer: Alumina
Correct Answer: CCl4
Correct Answer: water velocity can be increased conveniently to increase the overall heat transfer co-efficient because of its lower specific volume compared to steam.
Correct Answer: sensible heat is removed and the latent heat is added.
Correct Answer: tempering
Correct Answer: Gr0.25, Gr
Correct Answer: malleable
Correct Answer: hypo-eutectoid steel.
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.