When creating a pool of global addresses, which of the following can be used instead of the netmask command?

You can configure NAT three ways on a Cisco router: static, dynamic, and NAT Overload (PAT).

As in access-lists, you must configure your interfaces before NAT will provide any translations. On the inside networks you would use the command ip nat inside. On the outside interface, you will use the command ip nat outside.

The command clear ip nat translations * will clear all the active NAT entries in your translation table.

In order for NAT to provide translation services, you must have ip nat inside and ip nat outside configured on your router's interfaces.

The show ip nat statistics command displays a summary of the NAT configuration as well as counts of active translation types, hits to an existing mapping, misses (causing an attempt to create a mapping), and expired translations.

The host on the global network after translation is considered to be an outside global host.

Another term for port address translation is NAT Overload because that is the command used to enable port address translation.

As in access-lists, you must configure your interfaces before NAT will provide any translations. On the inside networks you would use the command ip nat inside. On the outside interface, you will use the command ip nat outside.

Anycast addresses identify multiple interfaces, which is the same as multicast; however, the big difference is that the anycast packet is only delivered to one address, the first one it finds defined in the terms of routing distance. This address can also be called one-to-one-of-many.

Link-local addresses are meant for throwing together a temporary LAN for meetings or a small LAN that is not going to be routed but needs to share and access files and services locally.