Discussion
Home ‣ Networking ‣ Wireless Technologies See What Others Are Saying!
- Question
How many non-overlapping channels are available with 802.11h?
Options- A. 3
- B. 12
- C. 23
- D. 40
- Correct Answer
- 23
ExplanationThe IEEE 802.11h standard provides an addition 11 channels to the 802.11a standard's 12 non-overlapping channel for a total of 23 non-overlapping channels. - 1. What information is displayed by the show hosts command?
- Temporary DNS entries
- The names of the routers created using the hostname command
- The IP addresses of workstations allowed to access the router
- Permanent name-to-address mappings created using the ip host command
- The length of time a host has been connected to the router via Telnet
Options- A. 1, 2 and 3
- B. 1 and 4
- C. 3, 4, and 5
- D. All of the above Discuss
- 2. You want to create a standard access list that denies the subnet of the following host: 172.16.144.17/21. Which of the following would you start your list with?
Options- A. access-list 10 deny 172.16.48.0 255.255.240.0
- B. access-list 10 deny 172.16.144.0 0.0.7.255
- C. access-list 10 deny 172.16.64.0 0.0.31.255
- D. access-list 10 deny 172.16.136.0 0.0.15.255 Discuss
- 3. Your company is running IGRP using an AS of 10. You want to configure EIGRP on the network but want to migrate slowly to EIGRP and don't want to configure redistribution. What command would allow you to migrate over time to EIGRP without configuring redistribution?
Options- A. router eigrp 11
- B. router eigrp 10
- C. router eigrp 10 redistribute igrp
- D. router igrp combine eigrp 10 Discuss
- 4. Which of the following commands sets a trunk port on a 2960 switch?
Options- A. trunk on
- B. trunk all
- C. switchport trunk on
- D. switchport mode trunk Discuss
- 5. Which of the following describes the creation of private networks across the Internet, enabling privacy and tunneling of non-TCP/IP protocols?
Options- A. HDLC
- B. Cable
- C. VPN
- D. IPSec
- E. xDSL Discuss
- 6. Cisco's Unified Wireless Solution provides a mesh solution. What devices do you absolutely need to purchase to run a Cisco solution?
- WCS
- Controller
- Access point
- Bridge
Options- A. 1 and 2
- B. 2 and 3
- C. 1 and 4 only
- D. 4 only Discuss
- 7. What two multicast addresses does OSPFv3 use?
- FF02::A
- FF02::9
- FF02::5
- FF02::6
Options- A. 2 only
- B. 3 only
- C. 1 and 3
- D. 3 and 4 Discuss
- 8. Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?
- show version
- show protocols
- show interfaces
- show controllers
- show ip interface
Options- A. 1, 2 and 4
- B. 2, 3 and 5
- C. 3 and 4 only
- D. None of the above Discuss
- 9. What is the frequency range of the IEEE 802.11b standard?
Options- A. 2.4Gbps
- B. 5Gbps
- C. 2.4GHz
- D. 5GHz Discuss
- 10. You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
Options- A. Router> ping
- B. Router> trace
- C. Router> show ip route
- D. Router> show interface Discuss
More questions
Correct Answer: 1 and 4
Explanation:
The
show hosts command provides information on temporary DNS entries and permanent name-to-address mappings created using the
ip host command.
Correct Answer: access-list 10 deny 172.16.144.0 0.0.7.255
Explanation:
First, you must know that a /21 is 255.255.248.0, which is a block size of 8 in the third octet. Counting by eight, this makes our subnet 144 in the third octet, and the wildcard for the third octet would be 7 since the wildcard is always one less than the block size.
Correct Answer: router eigrp 10
Explanation:
If you enable EIGRP on a router with the same autonomous system (AS) number, EIGRP will automatically redistribute IGRP into EIGRP. You will see the IGRP injected routes as external (EX) routes with an EIGRP AD of 170. This is a nice feature that lets you migrate slowly to EIGRP with no extra configuration.
Correct Answer: switchport mode trunk
Explanation:
To set a switch port to trunk mode, which allows all VLAN information to pass down the link, use the
switchport mode trunk command.
Correct Answer: VPN
Explanation:
A allows the creation of private networks across the Internet, enabling privacy and tunneling of non-TCP/IP protocols. A VPN can be set up across any type of link.
Correct Answer: 2 and 3
Explanation:
The Cisco Unified Wireless Solution is a great product, but you must purchase specialized devices. Cisco managed access points and a controller are the devices you need to purchase to run the Unified Wireless Solution.
Correct Answer: 3 and 4
Explanation:
Adjacencies and next-hop attributes now use link-local addresses, and OSPFv3 still uses multicast traffic to send its updates and acknowledgments with the addresses
FF02::5 for OSPF routers and
FF02::6 for OSPF designated routers. These are the replacements for
224.0.0.5 and
224.0.0.6, respectively.
Correct Answer: 2, 3 and 5
Explanation:
The commands
show protocols,
show interfaces, and
show ip interface will show you the layer 1 and 2 status and the IP addresses of your router's interfaces.
Correct Answer: 2.4GHz
Explanation:
The IEEE 802.11b and IEEE 802.11g standards both run in the 2.4GHz RF range.
Correct Answer: Router> trace
Explanation:
The command
traceroute (trace for short), which can be issued from user mode or privileged mode, is used to find the path a packet takes through an internetwork and will also show you where the packet stops because of an error on a router.
Comments
There are no comments.Programming
Copyright ©CuriousTab. All rights reserved.