logo

CuriousTab

CuriousTab

Discussion


Home Computer Science Automation System Comments

  • Question
  • What prevents a robotic instrument from running into other objects?


  • Options
  • A. negative image
  • B. functional manipulators
  • C. memory
  • D. sensory devices
  • E. None of the above

  • Correct Answer
  • sensory devices 


  • Automation System problems


    Search Results


    • 1. The program counter:

    • Options
    • A. decides which program to run
    • B. counts the number of instructions that have been executed
    • C. contains the address of the next instruction to be executed
    • D. is where arithmetic is done in a computer.
    • E. None of the above
    • Discuss
    • 2. Which of the following symbol modes are used to input of graphics to General CAD system?

    • Options
    • A. Live and Rectangle mode
    • B. Arc and Circle mode
    • C. Dimension and Alphanumeric mode
    • D. All of the above
    • E. None of the above
    • Discuss
    • 3. Flat panel displays are based on what type of technology?

    • Options
    • A. Direct view storage tube
    • B. Very large-scale integration (VLSI)
    • C. Solid state
    • D. RGB monitor
    • E. None of the above
    • Discuss
    • 4. Digital signals:

    • Options
    • A. can have three possible levels
    • B. are assigned values of 1 or 0 depending on the voltage level
    • C. have a sinusoidal shape.
    • D. have a frequency measured in units of hertz
    • E. None of the above
    • Discuss
    • 5. The name given to the test that determines whether a machine can think is the:

    • Options
    • A. Gaussian test
    • B. McCarthy test
    • C. Turing test
    • D. Boolean test
    • E. None of the above
    • Discuss
    • 6. Timing using a TM990 micro¬computer:

    • Options
    • A. require an external timer added by the user
    • B. is available on the standard CPU board
    • C. can be handled in software
    • D. both (b) and (c)
    • E. None of the above.
    • Discuss
    • 7. A program language:

    • Options
    • A. defines the form of the instruction
    • B. is always machine dependent
    • C. is never machine dependent
    • D. All of the above
    • E. None of the above
    • Discuss
    • 8. Which method is frequently used, especially in the early stages of design?

    • Options
    • A. The iterative design method
    • B. The direct method
    • C. The design selection method
    • D. All of the above
    • E. None of the above
    • Discuss
    • 9. Which of these controller types is the most accurate?

    • Options
    • A. Proportional plus integral
    • B. Proportional
    • C. Proportional plus derivative
    • D. Three mode
    • E. None of the above
    • Discuss
    • 10. A drum timer is a good example of:

    • Options
    • A. an output actuator
    • B. an input sensor
    • C. a position sensor
    • D. a sequence controller
    • E. None of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment