logo

CuriousTab

CuriousTab

Discussion


Home Computer Science Networking See What Others Are Saying!
  • Question
  • Frames from one LAN can be transmitted to another LAN via the device


  • Options
  • A. Router
  • B. Bridge
  • C. Repeater
  • D. Modem

  • Correct Answer
  • Bridge 


  • More questions

    • 1. Which of the following systems implementation approaches should be used if you want to run the old system and the new system at the same time for a specified period?

    • Options
    • A. direct
    • B. pilot
    • C. phased
    • D. parallel
    • E. None of the above
    • Discuss
    • 2. In his landmark book Cybernetics, Norbert Wiener suggested a way of modeling scientific phenomena using not energy, but:

    • Options
    • A. mathematics
    • B. intelligence
    • C. information
    • D. history
    • E. None of the above
    • Discuss
    • 3. RTS stands for:

    • Options
    • A. ready to start
    • B. ready to switch
    • C. request to send
    • D. request to scan
    • E. ready to set
    • Discuss
    • 4. A programmable controller:

    • Options
    • A. allows faster machine checkout
    • B. is easier to troubleshoot than standard relay logic
    • C. both (a) and (b)
    • D. All of the above
    • E. None of the above
    • Discuss
    • 5. A battery is a device composed of one or more:

    • Options
    • A. chemical cells
    • B. voltage generators
    • C. solar cells
    • D. piezoeletric cells
    • E. None of the above
    • Discuss
    • 6. Convert the 080D4E machine language instructions into assembly language, assuming that they were not generated by pseudo-ops:

    • Options
    • A. ASRA
    • B. LOADA h#OD4E, i
    • C. STOREA h#014B, d
    • D. ADDA h#01FE, i
    • Discuss
    • 7. The packaged design includes all of the following except;

    • Options
    • A. program flowcharts
    • B. system configuration
    • C. module descriptions
    • D. All of the above
    • E. None of the above
    • Discuss
    • 8. After doing a low-level format, what would be the next step in configuring the hard drive in a system?

    • Options
    • A. Format DOS partition
    • B. Install operating system
    • C. Configure DMA channel and back up interrupt
    • D. Partition hard disk
    • E. None of the above
    • Discuss
    • 9. You are installing an IDE hard drive that will be your boot drive. Which is the correct order of steps that need to be followed?

    • Options
    • A. jumper properly, auto-detect(or configure manually) in CMOS, low level format, high level format, partition
    • B. jumper properly, auto-detect(or configure manually) in CMOS, partition, high level format with / s switch
    • C. jumper properly, partition, auto-detect(or configure manually in CMOS, high level format with /s switch
    • D. jumper properly, auto-detect in CMOS, regular format
    • E. jumper properly, partition, low level format, high level format
    • Discuss
    • 10. Related fields in a data base are grouped to form

    • Options
    • A. data file
    • B. data record
    • C. menu
    • D. bank
    • E. None of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment