logo

CuriousTab

CuriousTab

Discussion


Home Computer Science Networking Comments

  • Question
  • What are the most commonly used transmission speeds in BPS used in data communication?


  • Options
  • A. 300
  • B. 1200
  • C. 2400
  • D. 9600
  • E. None of the above

  • Correct Answer
  • 9600 


  • Networking problems


    Search Results


    • 1. What can greatly reduce TCP/IP configuration problems?

    • Options
    • A. WINS Server
    • B. WINS Proxy
    • C. DHCP Server
    • D. PDC
    • E. None of the above
    • Discuss
    • 2. What is the port number for NNTP?

    • Options
    • A. 119
    • B. 80
    • C. 79
    • D. 70
    • Discuss
    • 3. What is the default subnet mask for a class C network?

    • Options
    • A. 127.0.0.1
    • B. 255.0.0.0
    • C. 255.255.0.0
    • D. 255.255.255.0
    • E. None of the above
    • Discuss
    • 4. Usually, it takes 10-bits to represent one character. How many characters can be transmitted at a speed of 1200 BPS?

    • Options
    • A. 10
    • B. 12
    • C. 120
    • D. 1200
    • E. None of the above
    • Discuss
    • 5. Which of the following is used for modulation and demodulation?

    • Options
    • A. modem
    • B. protocols
    • C. gateway
    • D. multiplexer
    • E. None of the above
    • Discuss
    • 6. The probability that a single bit will be in error on a typical public telephone line using 4800 bps modem is 10 to the power -3. If no error detection mechanism is used, the residual error rate for a communication line using 9-bit frames is approximately equal to

    • Options
    • A. 0.003
    • B. 0.009
    • C. 0.991
    • D. 0.999
    • E. None of the above
    • Discuss
    • 7. When you ping the loopback address, a packet is sent where?

    • Options
    • A. On the network
    • B. Down through the layers of the IP architecture and then up the layers again
    • C. Across the wire
    • D. through the loopback dongle
    • E. None of the above
    • Discuss
    • 8. Which of the following TCP/IP protocol is used for transferring electronic mail messages from one machine to another?

    • Options
    • A. FTP
    • B. SNMP
    • C. SMTP
    • D. RPC
    • E. None of the above
    • Discuss
    • 9. Frames from one LAN can be transmitted to another LAN via the device

    • Options
    • A. Router
    • B. Bridge
    • C. Repeater
    • D. Modem
    • Discuss
    • 10. A remote batch-processing operation in which data is solely input to a central computer would require a:

    • Options
    • A. telegraph line
    • B. simplex lines
    • C. mixedband channel
    • D. All the above
    • E. None of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment