Discussion
Home ‣ Computer Science ‣ Computer Hardware Comments
- Question
Which Motherboard form factor uses one 20 pin connector
Options- A. ATX
- B. AT
- C. BABY AT
- D. All of the above
- E. None of the above
- Correct Answer
- ATX
- 1. ESD would cause the most damage to which component?
Options- A. Power supply
- B. Expansion board
- C. Monitor
- D. Keyboard
- E. None of the above Discuss
- 2. Most PCs give a single beep on bootup to indicate they are ok hardware wise. You boot your PC and don't get a beep. What should you check first?
Options- A. system board
- B. RAM
- C. microprocessor
- D. power supply
- E. speaker Discuss
- 3. The 34-pin connection on an I/O card is for?
Options- A. Floppy drive
- B. SCSI drive
- C. IDE drive
- D. Zip drive
- E. None of the above Discuss
- 4. A hard disk is divided into tracks which are further subdivided into:
Options- A. clusters
- B. sectors
- C. vectors
- D. heads
- E. None of the above Discuss
- 5. You have a system that periodically locks up. You have ruled out software, and now suspect that it is hardware. What should you do first that could help you narrow it down to the component at fault?
Options- A. rotate the RAM
- B. replace the RAM
- C. replace the level 2 cache SIMM
- D. disable the CPU cache in CMOS
- E. replace the CPU Discuss
- 6. What product is used to clean smudged keys on a keyboard?
Options- A. TMC solvent
- B. Silicone spray
- C. Denatured alcohol
- D. All-purpose cleaner
- E. None of the above Discuss
- 7. With respect to a network interface card, the term 10/100 refers to
Options- A. protocol speed
- B. a fiber speed
- C. megabits per seconds
- D. minimum and maximum server speed
- E. None of the above Discuss
- 8. When installing a SCSI CD-ROM drive, you must set the CD-ROM SCSI adapter to:
Options- A. B0007
- B. An unused SCSI address
- C. The same address as the SCSI device before the CD-ROM
- D. SCSI ID=1
- E. None of the above Discuss
- 9. Voltage is measured:
Options- A. in parallel
- B. in series
- C. after breaking the circuit
- D. after checking resistance
- E. after checking current Discuss
- 10. ESD would cause the most damage to which component?
Options- A. Power supply
- B. Expansion board
- C. Monitor
- D. Keyboard
- E. None of the above Discuss
Computer Hardware problems
Search Results
Correct Answer: Expansion board
Correct Answer: speaker
Correct Answer: Floppy drive
Correct Answer: sectors
Correct Answer: disable the CPU cache in CMOS
Correct Answer: All-purpose cleaner
Correct Answer: megabits per seconds
Correct Answer: An unused SCSI address
Correct Answer: in parallel
Correct Answer: Expansion board
Comments
There are no comments.More in Computer Science:
Programming
Copyright ©CuriousTab. All rights reserved.