logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electrical Engineering ‣ Time Response of Reactive Circuits Comments
  • Question

  • An integrator consists of a 3.3 kΩ resistor and a 2 µF capacitor. A single 30 V, 6 ms pulse is applied to the input. How much will the capacitor charge?


  • Options
  • A. 10.3 V
  • B. 30 V
  • C. 12.09 V
  • D. 17.91 V

  • Correct Answer
  • 17.91 V 

    • Time Response of Reactive Circuits problems

    Search Results

    • 1. In electronic systems, repetitive-pulse waveforms are encountered

    • Options
    • A. more often than single pulses
    • B. less often than single pulses
    • C. about as often as single pulses
    • D. twice as often as single pulses
      • Discuss
    • 2. When a 12 V input pulse with a width equal to one time constant is applied to an RC integrator, the capacitor charges to

    • Options
    • A. 0 V
    • B. 12 V
    • C. 6.3 V
    • D. 7.56 V
      • Discuss
    • 3. Referring to the above figure, determine the voltage level that the output will reach during the pulse.


    • Options
    • A. 0 V
    • B. 15 V
    • C. 6.3 V
    • D. 9.45 V
      • Discuss
    • 4. When a 15 V input pulse with a width equal to two time constants is applied to an RC integrator, the capacitor charges to

    • Options
    • A. 15 V
    • B. 12.9 V
    • C. 8.6 V
    • D. 19.45 V
      • Discuss
    • 5. Referring to Problem 5, how long will it take the capacitor to discharge if the internal resistance of the pulse source is 100 Ω?

    • Options
    • A. 300 µs
    • B. 600 µs
    • C. 900 µs
    • D. 1.5 ms
      • Discuss
    • 6. A single 6 V pulse with a width of 600 µs is applied to an integrator consisting of a 150 kΩ resistor and a 0.002 µF capacitor. To what voltage will the capacitor charge?

    • Options
    • A. 0 V
    • B. 3.78 V
    • C. 5.16 V
    • D. 6 V
      • Discuss
    • 7. The output of an RC integrator is taken across the

    • Options
    • A. diode
    • B. capacitor
    • C. resistor
    • D. source
      • Discuss
    • 8. Referring to the give circuit, the output will


    • Options
    • A. decay to zero at the end of the pulse
    • B. reach 6 V at the end of the pulse
    • C. reach 3.78 V at the end of the pulse
    • D. reach 5.16 V at the end of the pulse
      • Discuss
    • 9. An RC differentiator acts as a

    • Options
    • A. low-pass filter
    • B. high-pass filter
    • C. band-pass filter
    • D. band-stop filter
      • Discuss
    • 10. The total resistance of a series circuit is equal to the difference between the largest and smallest value resistors.

    • Options
    • A. True
    • B. False
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright İCuriousTab. All rights reserved.