Discussion
Home ‣ Electrical Engineering ‣ Magnetism and Electromagnetism Comments
- Question
The voltage induced across a certain coil is 200 mV. A 120 Ω resistor is connected to the coil terminals. The induced current is
Options- A. 1.7 mA
- B. 16 mA
- C. 12 mA
- D. 120 mA
- Correct Answer
- 1.7 mA
- 1. There is 900 mA of current through a wire with 40 turns. What is the reluctance of the circuit if the flux is 400 µWb?
Options- A. 14,400 At/Wb
- B. 1,440 At/Wb
- C. 9,000 At/Wb
- D. 90,000 At/Wb Discuss
- 2. When a solenoid is activated, the force that moves the plunger is
Options- A. an electromagnetic field
- B. a permanent magnetic field
- C. varying voltage
- D. a steady current Discuss
- 3. What is the reluctance of a material that has a length of 0.07 m, a cross-sectional area of 0.014 m2, and a permeability of 4,500 µWb/At × m?
Options- A. 1111 At/Wb
- B. 111 At/Wb
- C. 11 At/Wb
- D. 1 At/Wb Discuss
- 4. When the current through the coil of an electromagnet reverses, the
Options- A. direction of the magnetic field reverses
- B. direction of the magnetic field remains unchanged
- C. magnetic field expands
- D. magnetic field collapses Discuss
- 5. If a loop in a basic dc generator suddenly begins rotating at a faster speed, the induced voltage
Options- A. remains unchanged
- B. reverses polarity
- C. increases
- D. decreases Discuss
- 6. An electromagnetic field exists only when there is
Options- A. an increasing current
- B. decreasing current
- C. voltage
- D. current Discuss
- 7. A coil of wire is placed in a changing magnetic field. If the number of turns in the coil is decreased, the voltage induced across the coil will
Options- A. increase
- B. decrease
- C. remain constant
- D. be excessive Discuss
- 8. A basic one-loop dc generator is rotated at 90 rev/s. How many times each second does the dc output voltage peak (reach maximum)?
Options- A. 90
- B. 180
- C. 270
- D. 360 Discuss
- 9. What is the flux density when the flux is 5.5 µWb and the cross-sectional area is 6 × 10?3 m2?
Options- A. 91.7 µT
- B. 917 µT
- C. 91 T
- D. 9.7 T Discuss
- 10. If the steel disk in a crankshaft position sensor has stopped with the tab in the magnet's air gap, the induced voltage
Options- A. increases
- B. decreases
- C. is zero
- D. will remain constant Discuss
Magnetism and Electromagnetism problems
Search Results
Correct Answer: 90,000 At/Wb
Correct Answer: an electromagnetic field
Correct Answer: 1111 At/Wb
Correct Answer: direction of the magnetic field reverses
Correct Answer: increases
Correct Answer: current
Correct Answer: decrease
Correct Answer: 180
Correct Answer: 917 µT
Correct Answer: is zero
Comments
There are no comments.More in Electrical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.