logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electrical Engineering ‣ Circuit Theorems in AC Analysis Comments
  • Question

  • Determine VTH when R1 is 180 Ω and XL is 90 Ω.

    Determine VTH when R1 is 180 ? and XL is 90 ?. 135?63.4° V 13.5?63.4° V 12.2?0° V 122?0° V


  • Options
  • A. 135∠63.4° V
  • B. 13.5∠63.4° V
  • C. 12.2∠0° V
  • D. 122∠0° V

  • Correct Answer
  • 13.5∠63.4° V 

    • Circuit Theorems in AC Analysis problems

    Search Results

    • 1. The Norton equivalent current is

    • Options
    • A. the current through the load
    • B. the open-current from the source
    • C. the short circuit current
    • D. none of the above
      • Discuss
    • 2. Referring to the given circuit, find ZTH if VS is 18∠0° V.


    • Options
    • A. 9.82 ∠?51.3° kΩ
    • B. 9.38∠?51.3° kΩ
    • C. 180 ∠?38.3° kΩ
    • D. 19.2 ∠?38.3° kΩ
      • Discuss
    • 3. If the value of C in a series RLC circuit is decreased, the resonant frequency

    • Options
    • A. is not affected
    • B. increases
    • C. is reduced to zero
    • D. decreases
      • Discuss
    • 4. Referring to Problem 8, the total current is

    • Options
    • A. 1.5 A
    • B. 573 mA
    • C. 5.73 A
    • D. 1.19 A
      • Discuss
    • 5. A 12 Ω resistor, a 40 µF capacitor, and an 8 mH coil are in series across an ac source. The resonant frequency is

    • Options
    • A. 28.1 Hz
    • B. 281 Hz
    • C. 2,810 Hz
    • D. 10 kHz
      • Discuss
    • 6. Referring to the given circuit, determine ZTH as seen by RL.


    • Options
    • A. 1444∠?48.5° Ω
    • B. 4176 ∠?73.3° Ω
    • C. 956 ∠?48.5° Ω
    • D. 1444 ∠?73.3° Ω
      • Discuss
    • 7. The two basic components of a Thevenin equivalent ac circuit are

    • Options
    • A. the equivalent voltage source and the equivalent series impedance
    • B. the equivalent voltage source and the equivalent series resistance
    • C. the equivalent voltage source and the equivalent parallel impedance
    • D. the equivalent voltage source and the equivalent parallel resistance
      • Discuss
    • 8. Referring to the given circuit, L


    • Options
    • A. must be in parallel with RL
    • B. must be placed in parallel with VS
    • C. must have a reactance equal to XC
    • D. has no effect on the result
      • Discuss
    • 9. For the given circuit, find VTH for the circuit external to RL.


    • Options
    • A. 4.69∠51.3° V
    • B. 4.69∠38.7° V
    • C. 469∠38.7° mV
    • D. 6∠0° V
      • Discuss
    • 10. In applying the superposition theorem,

    • Options
    • A. the sources are considered one at a time with all others replaced by their internal impedance
    • B. all sources are considered independently
    • C. all sources are considered simultaneously
    • D. the sources are considered one at a time with all others replaced by their internal resistance
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.