Discussion
Home ‣ Electrical Engineering ‣ RLC Circuits and Resonance Comments
- Question
A 15 Ω resistor, an inductor with 8 Ω inductive reactance, and a capacitor with 12 Ω capacitive reactance are in parallel across an ac voltage source. The circuit impedance is
Options- A. 12.7 Ω
- B. 127 Ω
- C. 4,436 Ω
- D. 6,174 Ω
- Correct Answer
- 12.7 Ω
- 1. A resistor of 3 kΩ, a 0.05 µF capacitor, and a 120 mH coil are in series across a 5 kHz, 20 V ac source. What is the impedance, expressed in polar form?
Options- A. 636 Ω
- B. 3,769 Ω
- C. 433 Ω
- D. 4,337 Ω Discuss
- 2. A resonant circuit has a lower critical frequency of 7 kHz and an upper critical frequency of 13 kHz. The bandwidth of the circuit is
Options- A. 7 kHz
- B. 13 kHz
- C. 20 kHz
- D. 6 kHz Discuss
- 3. Referring to Problem 20, what is the total parallel resistance (Rp(tot))?
Options- A. 4.99 Ω
- B. 499 Ω
- C. 4,992 Ω
- D. 6,800 Ω Discuss
- 4. A 200 Ω resistor, a coil with 30 Ω of reactance, and a capacitor of unknown reactance are in series across an ac source. The circuit is at resonance. Circuit impedance
Options- A. is 230 Ω
- B. is 170 Ω
- C. is 200 Ω
- D. cannot be determined Discuss
- 5. A certain series resonant circuit has a bandwidth of 2 kHz. If the existing coil is replaced with one having a higher value of Q, the bandwidth will
Options- A. increase
- B. remain the same
- C. decrease
- D. be less selective Discuss
- 6. A 90 Ω resistor, a coil with 30 Ω of reactance, and a capacitor with 50 Ω of reactance are in series across a 12 V ac source. The current through the resistor is
Options- A. 9 mA
- B. 90 mA
- C. 13 mA
- D. 130 mA Discuss
- 7. A 9 mH coil is in parallel with a 0.015 µF capacitor across an 18 kHz ac source. The coil's internal resistance, RW, is 60 Ω. The circuit impedance is
Options- A. 17,340 Ω
- B. 1,734 Ω
- C. 290 Ω
- D. 1,018 Ω Discuss
- 8. A 15 Ω resistor, a 220 µH coil, and a 60 pF capacitor are in series across an ac source. What is the bandwidth of the circuit?
Options- A. 138 MHz
- B. 10,866 Hz
- C. 1,907 Hz
- D. 138 kHz Discuss
- 9. In a series RLC circuit that is operating above the resonant frequency, the current
Options- A. lags the applied voltage
- B. leads the applied voltage
- C. is in phase with the applied voltage
- D. is zero Discuss
- 10. In a certain series resonant circuit, VC = 125 V, VL = 125 V, and VR = 40 V. The value of the source voltage is
Options- A. 125 V
- B. 250 V
- C. 290 V
- D. 40 V Discuss
RLC Circuits and Resonance problems
Search Results
Correct Answer: 4,337 Ω
Correct Answer: 6 kHz
Correct Answer: 4,992 Ω
Correct Answer: is 200 Ω
Correct Answer: decrease
Correct Answer: 130 mA
Correct Answer: 17,340 Ω
Correct Answer: 10,866 Hz
Correct Answer: lags the applied voltage
Correct Answer: 40 V
Comments
There are no comments.More in Electrical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.