logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Microwave Communication Comments

  • Question
  • Which of the following devices uses a slow wave structure?


  • Options
  • A. Klystron two cavity amplifier
  • B. Klystron multicavity amplifier
  • C. Reflex klystron oscillator
  • D. TWT

  • Correct Answer
  • TWT 

    Explanation
    In a klystron the resonant structure limits the bandwidth.

    A TWT is a broadband device. Its main components are electron gun (to produce the electron beam) and a structure supporting the slow electromagnetic wave.

    The velocity of wave propagation along the helix structure is less than velocity of light.

    The beam and wave travel along the structure at the same speed.

    Thus interaction occurs between beam and wave and the beam delivers energy to the RF wave.

    Therefore the signal gets strengthened and amplified output is delivered at the other end of tube.

    The main features of TWT are :

    1. Frequency range - 0.5 GHz to 90 GHz

    2. Power output - 5 mW at low frequencies(less than 20 GHz) 250 kW (continuous wave) at 3 GHz 10 MW (pulsed) at 3 GHz

    3. Efficiency - about 5 to 20%

    4. Noise - about 5 dB for low power TWT 25 dB for high power TWT

    TWT is used as RF amplifier in broadband microwave receivers, repeater amplifier in broad band communication systems, communication satellites etc.


    Microwave Communication problems


    Search Results


    • 1. For a 50 ? resistor for 3 GHz application, the stray capacitance should be less than

    • Options
    • A. 1 ?F
    • B. 1 nF
    • C. 1 pF
    • D. 0.1 pF
    • Discuss
    • 2. Assertion (A): TWT uses a focussing mechanism to prevent the electron beam from spreading.

      Reason (R): In a TWT the electron beam has to travel a much longer distance than in klystron.


    • Options
    • A. Both A and R are correct and R is correct explanation of A
    • B. Both A and R are correct but R is not correct explanation of A
    • C. A is correct but R is wrong
    • D. A is wrong but R is correct
    • Discuss
    • 3. In a klystron amplifier the input cavity is called

    • Options
    • A. buncher
    • B. catcher
    • C. Pierce gun
    • D. collector
    • Discuss
    • 4. Microwave resonators are used in

    • Options
    • A. microwave oscillators
    • B. microwave narrow band amplifier
    • C. microwave frequency metres
    • D. all of the above
    • Discuss
    • 5. A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is

    • Options
    • A. 4000 ?
    • B. 400 ?
    • C. 40 ?
    • D. 4 ?
    • Discuss
    • 6. Which of the following can be accessed only sequentially?

    • Options
    • A. Floppy disk
    • B. Hard disk
    • C. Magnetic tape
    • D. ROM
    • Discuss
    • 7. In ALU 1C 74181 the addition and subtraction is in

    • Options
    • A. 2's complement
    • B. 1's complement
    • C. binary
    • D. none of the above
    • Discuss
    • 8. Which of the following is a computer language?

    • Options
    • A. MS WORD
    • B. Page maker
    • C. MS EXCEL
    • D. LISP
    • Discuss
    • 9. During processing the instructions, data, intermediate results and final results in a computer are held in

    • Options
    • A. CPU
    • B. ALU
    • C. Primary memory
    • D. Secondary memory
    • Discuss
    • 10. When .4546 E 5 and .5433 E 7 are to be added in normalized floating point mode

    • Options
    • A. none of the numbers is changed to any other form
    • B. .4546 E 5 is changed .004546 E 7 and .5433 E 7 is not changed
    • C. .5433 E 7 is changed to 54.33 E 5 and .4546 E 5 is not changed
    • D. both the numbers are changed and their exponents are made equal to 6
    • Discuss


    Comments

    There are no comments.

Enter a new Comment