logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Communication Systems Comments

  • Question
  • A generator is feeding power to a transmission line of characteristic impedance Z0. The line is terminated in impedance ZL. Standing waves will be set up if


  • Options
  • A. ZL = Z0
  • B. ZL < Z0
  • C. ZL > Z0
  • D. both (b) and (c)

  • Correct Answer
  • both (b) and (c) 

    Explanation
    Both the case, i.e., ZL > Z0 and ZL < Z0 give rise to standing waves.

    Communication Systems problems


    Search Results


    • 1. A woofer should be fed from the input through a

    • Options
    • A. low pass filter
    • B. high pass filter
    • C. band pass filter
    • D. band stop filter
    • Discuss
    • 2. A carrier wave carries information.

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. A modem is classified as low speed if data rate handled is

    • Options
    • A. upto 100 bps
    • B. upto 250 bps
    • C. upto 400 bps
    • D. upto 600 bps
    • Discuss
    • 4. Counterpoise is used in coils having

    • Options
    • A. high resistivity
    • B. low resistivity
    • C. medium resistivity
    • D. both (b) and (c)
    • Discuss
    • 5. The velocity of sound waves in air

    • Options
    • A. is constant at all temperatures
    • B. varies directly as temperature
    • C. varies inversely as absolute temperature
    • D. varies directly as square root of absolute temperature
    • Discuss
    • 6. A 400 W carrier is amplitude modulated with m = 0.75. The total power in AM is

    • Options
    • A. 400 W
    • B. 512 W
    • C. 588 W
    • D. 650 W
    • Discuss
    • 7. In sound recording the degree of pre-emphasis is about 6 dB/ octave.

    • Options
    • A. True
    • B. False
    • Discuss
    • 8. Tracking of extra terrestrial objects requires

    • Options
    • A. high transmitting power
    • B. very sensitive receiver
    • C. fully steerable antenna
    • D. all of the above
    • Discuss
    • 9. A 1000 kHz carrier is simultaneously modulated with 300 Hz, 800 Hz and 2 kHz audio sine waves. Which of the following frequency is least likely to be present in the output?

    • Options
    • A. 1002 kHz
    • B. 1000 kHz
    • C. 999.2 kHz
    • D. 998.0 kHz
    • Discuss
    • 10. If C is capacity of noisy channel, (bits/s), ?f is bandwidth Hz and S/N is signal to noise ratio, then

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment