If duty cycle is a and the load is a resistance R, the rms value of output volta

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Power Electronics Comments

Question
If duty cycle is a and the load is a resistance R, the rms value of output voltage is
Options
A. aV
B. a V
C. a²V
D.

Correct Answer

a V

Explanation

RMS output voltage

V_L = a V.

Power Electronics problems

Search Results

2. In single phase half wave regulator, the average current over one full cycle
Options
A. is always positive
B. may be positive or negative
C. may be negative
D. is always negative

3. Two thyristor of same rating and same specifications
Options
A. will have equal turn on and turn off periods
B. will have equal turn on but unequal turn off periods
C. may have equal or unequal turn on and turn off periods
D. will have unequal turn on and turn off periods

4. A dc separately excited motor has constant field current. The armature is fed from a single phase supply through a full converter. When a = 0, speed is 500 rpm. If a = 45�, the speed is likely to be
Options
A. about 350 rpm
B. about 250 rpm
C. about 175 rpm
D. about 125 rpm

5. The dynamic equalising circuit consists of a series combination of capacitor C and resistor R_C across each thyristor. This resistance R_C (along with parallel connected diode)
Options
A. limits charging current
B. limits discharging current
C. limits both charging and discharging currents
D. none of the above

7. An 8 bit DAC has a full scale output of 2 mA and full scale error of � 0.5%. If input is 10000000 the range of outputs is
Options
A. 994 to 1014 ?A
B. 990 to 1020 ?A
C. 800 to 1200 ?A
D. none of the above

9. For the K map in the given figure the simplified Boolean expression is
Options
A. A C + A D + ABC
B. A C + A D + ABC
C. A C + A D + ACD
D. A C + A D + AB C

Comments

There are no comments.

More in Electronics and Communication Engineering: