The dynamic equalising circuit consists of a series combination of capacitor C a

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Power Electronics Comments

Question
The dynamic equalising circuit consists of a series combination of capacitor C and resistor R_C across each thyristor. This resistance R_C (along with parallel connected diode)
Options
A. limits charging current
B. limits discharging current
C. limits both charging and discharging currents
D. none of the above

Correct Answer

limits discharging current

Explanation

Discharge current flows through R_e .

Power Electronics problems

Search Results

1. In a single phase full wave regulator, the firing angles in the positive and negative half cycles are generally
Options
A. equal
B. different
C. equal or different
D. different but sometimes equal

2. In a 3 phase fully controlled converter the firing frequency is
Options
A. 3 times the line frequency
B. 6 times the line frequency
C. 9 times the line frequency
D. 12 times the line frequency

3. The terminals of a power MOSFET are called
Options
A. emitter, base, collector
B. source, gate, drain
C. source, base, drain
D. emitter, gate, drain

5. A single phase half wave rectifier is feeding a resistive load. When a = 0, dc output voltage is 127 V. When a = 30�, the dc output voltage will be about
Options
A. 127 V
B. 120 V
C. 110 V
D. 100 V

6. A dc separately excited motor has constant field current. The armature is fed from a single phase supply through a full converter. When a = 0, speed is 500 rpm. If a = 45�, the speed is likely to be
Options
A. about 350 rpm
B. about 250 rpm
C. about 175 rpm
D. about 125 rpm

7. Two thyristor of same rating and same specifications
Options
A. will have equal turn on and turn off periods
B. will have equal turn on but unequal turn off periods
C. may have equal or unequal turn on and turn off periods
D. will have unequal turn on and turn off periods

8. In single phase half wave regulator, the average current over one full cycle
Options
A. is always positive
B. may be positive or negative
C. may be negative
D. is always negative

10. If duty cycle is a and the load is a resistance R, the rms value of output voltage is
Options
A. aV
B. a V
C. a²V
D.

Comments

There are no comments.

More in Electronics and Communication Engineering: