Discussion
Home ‣ Electronics and Communication Engineering ‣ Radio Receivers Comments
- Question
In a communication system, noise is most likely to affect the signal
Options- A. at the transmitter
- B. in the channel
- C. in the information source
- D. at the destination
- Correct Answer
- in the channel
- 1. Standard AM radio broadcasts are confined to
Options- A. MF
- B. HF
- C. VHF
- D. UHF Discuss
- 2. In a ratio detector
Options- A. the linearity is worse than in a phase discriminator
- B. the output is twice that obtainable from a similar phase discriminator
- C. stabilization against signal strength variations is provided
- D. the circuit is the same as in a discriminator, except that the diodes are reversed Discuss
- 3. Most popular IF for receivers tuning to 540 to 1650 kHz is
Options- A. 433 kHz
- B. 455 kHz
- C. 545 kHz
- D. 555 kHz Discuss
- 4. Padders are used in a receiver to
Options- A. discard the carrier
- B. facilitate tracking
- C. filter the input signal
- D. suppress noise Discuss
- 5. As compared to tuned radio frequency receivers which of the following is the advantage of using superheterodyne receivers?
Options- A. High gain and better sensitivity
- B. Better selectivity at high frequencies
- C. Stability
- D. Noise suppression Discuss
- 6. In a receiver, which of the following device has IF input but RF output?
Options- A. Demodulator
- B. Loudspeaker
- C. Audio amplifier
- D. Frequency changer Discuss
- 7. Which of the following noise does not occur in transistors?
Options- A. Partition noise
- B. Shot noise
- C. Flicker noise
- D. Resistance noise Discuss
- 8. A transmitter serial current contains
Options- A. carrier frequencies
- B. audio frequencies
- C. radio frequencies
- D. none of the above Discuss
- 9. It is known that noise phase modulates the FM wave. As the noise side band frequency approaches the carrier frequency, the noise amplitude
Options- A. will increase
- B. will decrease
- C. will remain constant
- D. will reduce to negligible value Discuss
- 10. In superheterodyne receivers, the local oscillator is used to
Options- A. detect the modulating signal
- B. amplify the received modulated carrier
- C. shift the frequency of the received modulated carrier to the IF band Discuss
Radio Receivers problems
Search Results
Correct Answer: MF
Correct Answer: the linearity is worse than in a phase discriminator
Correct Answer: 455 kHz
Correct Answer: facilitate tracking
Correct Answer: High gain and better sensitivity
Correct Answer: Demodulator
Correct Answer: Partition noise
Correct Answer: radio frequencies
Correct Answer: will decrease
Correct Answer: shift the frequency of the received modulated carrier to the IF band
Comments
There are no comments.More in Electronics and Communication Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.