Discussion
Home ‣ Electronics and Communication Engineering ‣ Radio Receivers Comments
- Question
Most popular IF for receivers tuning to 540 to 1650 kHz is
Options- A. 433 kHz
- B. 455 kHz
- C. 545 kHz
- D. 555 kHz
- Correct Answer
- 455 kHz
- 1. Padders are used in a receiver to
Options- A. discard the carrier
- B. facilitate tracking
- C. filter the input signal
- D. suppress noise Discuss
- 2. As compared to tuned radio frequency receivers which of the following is the advantage of using superheterodyne receivers?
Options- A. High gain and better sensitivity
- B. Better selectivity at high frequencies
- C. Stability
- D. Noise suppression Discuss
- 3. When fs is the signal frequency and fi is the intermediate frequency, then image frequency fsi is given by
Options- A. fsi = fs - 2fi
- B. fsi = fs + 2fi
- C.
- D.
Discuss
- 4. Modulated carrier power in FM
Options- A. increases with modulating signal power
- B. decreases with modulating signal power
- C. is independent of the modulating signal power
- D. none Discuss
- 5. A heterodyne frequency changer is called a
Options- A. Modulator
- B. Mixer
- C. Demodulator
- D. Frequency translator Discuss
- 6. In a ratio detector
Options- A. the linearity is worse than in a phase discriminator
- B. the output is twice that obtainable from a similar phase discriminator
- C. stabilization against signal strength variations is provided
- D. the circuit is the same as in a discriminator, except that the diodes are reversed Discuss
- 7. Standard AM radio broadcasts are confined to
Options- A. MF
- B. HF
- C. VHF
- D. UHF Discuss
- 8. In a communication system, noise is most likely to affect the signal
Options- A. at the transmitter
- B. in the channel
- C. in the information source
- D. at the destination Discuss
- 9. In a receiver, which of the following device has IF input but RF output?
Options- A. Demodulator
- B. Loudspeaker
- C. Audio amplifier
- D. Frequency changer Discuss
- 10. Which of the following noise does not occur in transistors?
Options- A. Partition noise
- B. Shot noise
- C. Flicker noise
- D. Resistance noise Discuss
Radio Receivers problems
Search Results
Correct Answer: facilitate tracking
Correct Answer: High gain and better sensitivity
Correct Answer: fsi = fs + 2fi
Correct Answer: is independent of the modulating signal power
Correct Answer: Mixer
Correct Answer: the linearity is worse than in a phase discriminator
Correct Answer: MF
Correct Answer: in the channel
Correct Answer: Demodulator
Correct Answer: Partition noise
Comments
There are no comments.More in Electronics and Communication Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.