In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Radio Receivers Comments

Question
In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The image frequency at 25 MHz will be
Options
A. 24.09 MHz
B. 24.54 MHz
C. 25.45 MHz
D. 25.91 MHz

Correct Answer

25.91 MHz

Radio Receivers problems

Search Results

1. In a superheterodyne receiver, the IF is 455 kHz. If it is tuned to 1200 kHz, the image frequency will be
Options
A. 1655 kHz
B. 2110 kHz
C. 745 kHz
D. 910 kHz

2. In a radio receiver with simple AGC
Options
A. the highest AGC voltage is produced between stations
B. the faster the AGC time constant, the more accurate the output
C. an increase in signal strength produces more AGC
D. the audio stage gain is normally controlled by AGC

4. For the system in the given figure the characteristic equation is
Options
A.
B.
C. K(s + 1)(s + 3) = 0
D. s(s + 2) = 0

5. In a minimum phase system
Options
A. all poles lie in the left half plane
B. all zeros lie in the left half plane
C. all poles lie in the right half plane
D. all except one pole or zero lie in the left half plane

9. In a radio receiver, if the intermediate frequency is too low
Options
A. Image-frequency rejection will improve
B. Selectivity will be too sharp
C. The frequency selectivity of the local oscillator will have to be lowered
D. All of the above

10. In a broadcast superheterodyne receiver
Options
A. the local oscillator operates below the signal frequency
B. local oscillator frequency is normally double the IF
C. RF amplifier normally works at kHz above the carrier frequency
D. mixer input must be tuned to the signal frequency

Comments

More in Electronics and Communication Engineering: