logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics and Communication Engineering ‣ Analog Electronics Comments
  • Question

  • An exponential amplifier has diode in feedback path.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • False 

    Explanation
    It has resistance in feedback path.

    Analog Electronics problems

    Search Results

    • 1. In figure The minimum and maximum load currents are

    • Options
    • A. 0 and 60 mA
    • B. 0 and 120 mA
    • C. 10 mA and 60 mA
    • D. 10 mA and 120 mA
      • Discuss
    • 2. A bridge rectifier circuit has input of 50 Hz frequency. The load resistance is RL and filter capacitance is C. For good output wave shape, the time constant RLC should be at least equal to

    • Options
    • A. 10 ms
    • B. 20 ms
    • C. 50 ms
    • D. 100 ms
      • Discuss
    • 3. An amplifier with loop gain A? will be more stable for value of A? as

    • Options
    • A. 0.95
    • B. 0.7
    • C. 1.2
    • D. 1.5
      • Discuss
    • 4. The load impedance ZL of a CE amplifier has R and L in series. The phase difference between output and input will be

    • Options
    • A. 180°
    • B. 0
    • C. more than 90° but less than 180°
    • D. more than 180° but less than 270°
      • Discuss
    • 5. In figure what is the base current if VBE = 0.7 V

    • Options
    • A. 10 mA
    • B. 9.3 mA
    • C. 10 ?A
    • D. 9.3 ?A
      • Discuss
    • 6. Consider the following statements : A clamper circuit

      1. adds or subtracts a dc voltage to a waveform
      2. does not change the waveform
      3. amplifiers the waveform
      Which are correct?

    • Options
    • A. 1, 2
    • B. 1, 3
    • C. 1, 2, 3
    • D. 2, 3
      • Discuss
    • 7. Gain of the amplifier is 'A'. Then the I/P impedance and O/P impedance of the closed loop amplifier shown below would be

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 8. In a CE amplifier the input impedance is equal to the ratio of

    • Options
    • A. ac base voltage to ac base current
    • B. ac base voltage to ac emitter current
    • C. ac emitter voltage to ac collector current
    • D. ac collector voltage to ac collector current
      • Discuss
    • 9. A CB amplifier has re = 6 ?, RL = 600 ? and a = 0.98. The voltage gain is

    • Options
    • A. 100
    • B. 600 x 0.98
    • C. 98
    • D. 6
      • Discuss
    • 10. A stepper motor is

    • Options
    • A. a two phase induction motor
    • B. is a kind of rotating amplifier
    • C. is an electromagnetic transducer used to convert an angular position of shaft into electrical signal
    • D. is an electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.