An RC coupled amplifier has an open loop gain of 200 and a lower cutoff frequenc

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Analog Electronics Comments

Question
An RC coupled amplifier has an open loop gain of 200 and a lower cutoff frequency of 50 Hz. If negative feedback with ? = 0.1 is used, the lower cut off frequency will be
Options
A. about 50 Hz
B. about 5 Hz
C. about 2.38 Hz
D. about 70.5 Hz

Correct Answer

about 2.38 Hz

Explanation

New lower cutoff frequency =

An RC coupled amplifier has an open loop gain of 200 and a lower cutoff frequency of 50 Hz. If negat

.

Analog Electronics problems

Search Results

1. The input impedance of op-amp circuit of figure is
Options
A. 120 k ohm
B. 110 k ohm
C. infinity
D. 10 k ohm

2. For a system to work, as oscillator the total phase shift of the loop gain must be equal to
Options
A. 90�
B. 45�
C. 270�
D. 360�

3. If the input to the ideal comparator shown in the figure is a sinusoidal signal of 8 V (peak to peak) without any DC component, then the output of the comparator has a duty cycle of
Options
A. 1/2
B. 1/3
C. 1/6
D. 1/12

4. The transistor of following figure in Si diode with a base current of 40 ?A and I_CBO = 0, if V_BB = 6V, R_E = 2 k? and ? = 90, I_BQ = 20 ?A then R_B =
Options
A. 200 k?
B. 265 k?
C. 150 k?
D. 100 k?

5. The efficiency of a full wave rectifier using centre tapped transformer is twice that in full wave bridge rectifier.
Options
A. True
B. False

6. For a base current of 10 ?A, what is the value of collector current in common emitter if ?_dc = 100
Options
A. 10 ?A
B. 100 ?A
C. 1 mA
D. 10 mA

7. Assertion (A): CE amplifier is the most widely used BJT amplifier
Reason (R): CE amplifier has zero phase difference between input and output
Options
A. Both A and R are correct and R is correct explanation for A
B. Both A and R are correct but R is not correct explanation for A
C. A is correct R is wrong
D. A is wrong R is correct

10. S_i transistor of following figure has a = 0.9 and I_CE= 0, V_EE = 5 V and V_CC = 13 V, then R_E will be if I_EQ = 1 mA
Options
A. 3 k?
B. 4 k?
C. 5 k?
D. 4.3 k?

Comments

There are no comments.

More in Electronics and Communication Engineering: