logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Analog Electronics Comments

  • Question
  • A half wave diode rectifier has a capacitance input filter. If input voltage is Vm sin ?t, PIV is


  • Options
  • A. Vm
  • B. 2 Vm
  • C. 3 Vm
  • D. 4 Vm

  • Correct Answer
  • 2 Vm 

    Explanation
    Because capacitor charge is retained.

    Analog Electronics problems


    Search Results


    • 1. In figure ID = 4 mA. Then VS =

    • Options
    • A. 20 V
    • B. 4.4 V
    • C. 0.4 V
    • D. 0.44 V
    • Discuss
    • 2. In figure v1 = 8 V and v2 = 4 V. Which diode will conduct?

    • Options
    • A. D2 only
    • B. D1 only
    • C. Both D1 and D2
    • D. Neither D1 nor D2
    • Discuss
    • 3. To protect the diodes in a rectifier and capacitor input filter circuit it is necessary to use

    • Options
    • A. surge resistor
    • B. surge inductor
    • C. surge capacitor
    • D. both (a) and (b)
    • Discuss
    • 4. In the op-amp circuit of figure, V0 =

    • Options
    • A. Vi
    • B. 3 Vi
    • C. 5 Vi
    • D. 0.5 Vi
    • Discuss
    • 5. If an amplifier with gain of - 1000 and feedback factor ? = - 0.1 had a gain change of 20% due to temperature, the change in gain of the feedback amplifier would be

    • Options
    • A. 10%
    • B. 5%
    • C. 0.2%
    • D. 0.01%
    • Discuss
    • 6. The efficiency of a full wave rectifier using centre tapped transformer is twice that in full wave bridge rectifier.

    • Options
    • A. True
    • B. False
    • Discuss
    • 7. The transistor of following figure in Si diode with a base current of 40 ?A and ICBO = 0, if VBB = 6V, RE = 2 k? and ? = 90, IBQ = 20 ?A then RB =

    • Options
    • A. 200 k?
    • B. 265 k?
    • C. 150 k?
    • D. 100 k?
    • Discuss
    • 8. If the input to the ideal comparator shown in the figure is a sinusoidal signal of 8 V (peak to peak) without any DC component, then the output of the comparator has a duty cycle of

    • Options
    • A. 1/2
    • B. 1/3
    • C. 1/6
    • D. 1/12
    • Discuss
    • 9. For a system to work, as oscillator the total phase shift of the loop gain must be equal to

    • Options
    • A. 90°
    • B. 45°
    • C. 270°
    • D. 360°
    • Discuss
    • 10. The input impedance of op-amp circuit of figure is

    • Options
    • A. 120 k ohm
    • B. 110 k ohm
    • C. infinity
    • D. 10 k ohm
    • Discuss


    Comments

    There are no comments.

Enter a new Comment