In a resistance strain gauge, G = 2, stress = 1050 kg/cm2, R = 1000 ?. The value

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Measurements and Instrumentation Comments

Question
In a resistance strain gauge, G = 2, stress = 1050 kg/cm², R = 1000 ?. The value of ?R will be
Options
A. 2 ?
B. 3 ?
C. 4 ?
D. 1 ?

Correct Answer

1 ?

Explanation

In a resistance strain gauge, G = 2, stress = 1050 kg/cm2, R = 1000 ?. The value of ?R will be 2 ? 3

In a resistance strain gauge, G = 2, stress = 1050 kg/cm2, R = 1000 ?. The value of ?R will be 2 ? 3 .

Measurements and Instrumentation problems

Search Results

1. Which of the following is true about an impulse voltage?
Options
A. It is a unidirectional voltage
B. Chopped impulse flashover does not occur
C. Time taken to rise is equal to time taken to fall
D. RMS value is always less than 50% of average value

3. A moving iron instrument gives correct reading when used at
Options
A. low frequencies
B. high frequencies
C. only one frequency
D. all frequencies upto a certain value

4. A full wave rectifier type meter is used to measure the wave shape shown in figure. The voltmeter is calibrated to read rms value of sine wave. The reading of voltmeter will be
Options
A.
B.
C. 100 V
D. 111 V

5. Consider the following statements: In a differential amplifier using JFET, the differential output offset is due to
1. mismatch between FET parameters
2. difference in values of resistances used in circuit
3. variation in supply voltage.
Of the statements, the correct statements are
Options
A. 1 and 2
B. 1, 2, 3
C. 2, 3
D. 1, 3

6. In 3 phase power measurement by two wattmeter method, the reading of one wattmeter is zero. The power factor of load is
Options
A. 1
B. 0.5
C. 0
D. 0.8

7. Which power amplifier can deliver maximum load power?
Options
A. Class A
B. Class AB
C. Class B
D. Class C

8. A half wave diode circuit using ideal diode has an input voltage 20 sin ?t volts. Then average and rms values of output voltage are
Options
A. and 10 V
B. and 10 V
C. and 5 V
D. and 5 V

9. In figure v₁ = 8 V and v₂ = 8 V. Which diode will conduct?
Options
A. D₁ only
B. D₂ only
C. Both D₁ and D₂
D. Neither D₁ nor D₂

Comments

There are no comments.

More in Electronics and Communication Engineering: