logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Networks Analysis and Synthesis Comments

  • Question
  • Wave A = 100 sin ?t and wave B = 100 cos ?t. Then


  • Options
  • A. rms values of the two waves are equal
  • B. rms values of A is more than that of B
  • C. rms values of A is less than that of B
  • D. rms values of the two waves may or may not be equal

  • Correct Answer
  • rms values of the two waves are equal 

    Explanation
    Since peak values are equal, their rms values are equal irrespective of phase difference.

    Networks Analysis and Synthesis problems


    Search Results


    • 1. The synthesis of minimum function was suggested by

    • Options
    • A. O'Brune
    • B. R. Richards
    • C. Bott and Duffin
    • D. none of the above
    • Discuss
    • 2. In an ac circuit, the maximum and minimum values of power factor can be

    • Options
    • A. 2 and 0
    • B. 1 and 0
    • C. 0 and -1
    • D. 1 and -1
    • Discuss
    • 3. The terms RMS and average values apply only to sine waves.

    • Options
    • A. True
    • B. False
    • Discuss
    • 4. In a parallel resonant circuit, the circuit current at resonance is maximum.

    • Options
    • A. True
    • B. False
    • Discuss
    • 5. The drift velocity of electrons is

    • Options
    • A. very small as compared to speed of light
    • B. equal to speed of light
    • C. almost equal to speed of light
    • D. half the speed of light
    • Discuss
    • 6. Which of the following measurements using a dc potentiometer do not require standardisation of potentiometer?

    • Options
    • A. Measurement of unknown voltage
    • B. Measurement of resistance
    • C. Measurement of unknown current
    • D. Calibration of voltmeter
    • Discuss
    • 7. The coil of a moving coil meter has 100 turns, is 40 mm long and 30 mm wide. The control torque is 240 x 10-6 N-m on full scale. If B = 1 Wb/m2, range of meter is

    • Options
    • A. 1 mA
    • B. 2 mA
    • C. 3 mA
    • D. 4 mA
    • Discuss
    • 8. Which of the following are needed both for protection and metering?

    • Options
    • A. Wattmeters
    • B. Instrument transformers
    • C. Energy meters
    • D. Power factor meters
    • Discuss
    • 9. Figure shows an RC potentiometer to measure ac voltage. It is desired that V0/Vi should be independent of frequency. The value of C should be

    • Options
    • A. 10 ?F
    • B. 11 ?F
    • C. 0.1 ?F
    • D. 0.09 ?F
    • Discuss
    • 10. Two resistors R1 = 36 ? ± 5% and R2 = 75 ? ± 5% are connected in series. The total resistance is

    • Options
    • A. 111 ± 0 ?
    • B. 111 ± 2.778 ?
    • C. 111 ± 5.55 ?
    • D. 111 ± 7.23 ?
    • Discuss


    Comments

    There are no comments.

Enter a new Comment