and i(t) is a unit step, then V(t) in the steady state is given by 4/9 4/3 0 ? =

CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Networks Analysis and Synthesis Comments

Question
and i(t) is a unit step, then V(t) in the steady state is given by
Options
A. 4/9
B. 4/3
C. 0
D. ?

Correct Answer

4/9

Explanation

and i(t) is a unit step, then V(t) in the steady state is given by 4/9 4/3 0 ? = 4/9.

and i(t) is a unit step, then V(t) in the steady state is given by 4/9 4/3 0 ? = 4/9. = 4/9.

Networks Analysis and Synthesis problems

Search Results

1. In the circuit shown in given figure, the values of i(0⁺) and I(?), will be respectively
Options
A. zero and 1.5 A
B. 1.5 A and 3 A
C. 3 A and zero
D. 3 A and 1.5 A

2. The circuit in figure will act as ideal current source with respect to terminals A and B when frequency is
Options
A. 0
B. 1 rad/sec
C. 4 rad/sec
D. 16 rad/sec

4. The impedance matrices of two, two-port network are given by and . If these two networks are connected in series, the impedance matrix of the resulting two-port network will be
Options
A.
B.
C.
D. indeterminate

5. A 0.5 ?F capacitor is connected across a 10 V battery. After a long time, the circuit current and voltage across capacitor will be
Options
A. 0.5 A and 0 V
B. 0 A and 10 V
C. 20 A and 5 V
D. 0.05 A and 5 V

6. Which of the following pairs are correctly matched?
1. Brune's realisation : realisation with ideal transformer.
2. Cauer realisation : ladder realisation.
3. Bott Duffin realisation : with non ideal transformer.
Select the answer using the following codes:
Options
A. 1, 2 and 3
B. 2 and 3
C. 1 and 3
D. 1 and 2

7. In a minimum function
Options
A. the degree of numerator and denominator are equal
B. the degree of numerator and denominator are unequal
C. the degree of numerator is one more than degree of denominator
D. the degree of numerator is one less than degree of denominator

8. An RLC series circuit is underdamped. To make it overdamped, the value of R
Options
A. has to be increased
B. has to be decreased
C. has to be increased to infinity
D. has to be reduced to zero

9. A sinusoidal voltage has peak to peak value of 100 V. The rms value is
Options
A. 50 V
B. 70.7 V
C. 35.35 V
D. 141.41 V

10. A series RC circuit has R = 5 ? and C = 10 ?F. The current in the circuit is 5 sin 20000t. The applied voltage is
Options
A. 252 sin (20000t + 45�)
B. 252 sin (20000t - 45�)
C. 252 sin 20000t
D. 252 sin (20000t - 90�)

Comments

There are no comments.

More in Electronics and Communication Engineering: