Discussion
Home ‣ Civil Engineering ‣ Structural Design Specifications Comments
- Question
For the reinforced concrete member totally immersed in sea water, the normal cover provided for the reinforcing bars is further increased by
Options- A. 10 mm
- B. 20 mm
- C. 30 mm
- D. 40 mm
- E. 50 mm
- Correct Answer
- 40 mm
- 1. For rolled I-beams and channels, permissible tensile and compressive stresses does not exceed
Options- A. 1400 kg/cm2
- B. 1500 kg/cm2
- C. 1650 kg/cm2
- D. 1800 kg/cm2 Discuss
- 2. If the dimensions of a rectangular section of a short column are 15 cm x 20 cm, its unsupported length should be restricted to
Options- A. 9.0 m
- B. 10.0 m
- C. 11.0 m
- D. 12.0 m Discuss
- 3. For the plain reinforcing bars in compression, the permissible design bond stress in tension, is increased by
Options- A. 10%
- B. 15%
- C. 20%
- D. 25%
- E. 30% Discuss
- 4. Pick up the correct precaution while spilicing the reinforcing bars
Options- A. These are provided away from the sections of maximum stress
- B. These are staggered
- C. These are provided if the B.M. is more than 50% of M.R.
- D. Not more than half the bars are spliced at a section
- E. All the above. Discuss
- 5. A continuous beam shall be deemed to be a deep beam if the ratio of its effective span to overall depth, is
Options- A. 2.0
- B. 2.5
- C. less than 2
- D. less than 2.5 Discuss
- 6. The test strength of the sample is taken as the average of the strength of
Options- A. 2 specimens
- B. 3 specimens
- C. 4 specimens
- D. 5 specimens Discuss
- 7. The reduced level of third floor of a building near a column is 205.350 m. The reduced levels of the undersides of four beams supporting the fourth floor framing into the column mutually perpendicular are 208.350 m, 208.450 m, 208.500 m and 208.550 m. The supported length of the column is
Options- A. 3.000 m
- B. 3.100 m
- C. 3.150 m
- D. 3.200 m Discuss
- 8. Which one of the following linings is suitable for shield driven tunnels particularly in the subaqueous regions :
Options- A. Brick lining
- B. stone lining
- C. timber line
- D. cast iron lining
- E. concrete lining. Discuss
- 9. Pick up the explosive used for tunnelling in soft rocks from the following :
Options- A. blasting gelatine
- B. special gelatine
- C. ammonia dynamite
- D. semi-gelatine. Discuss
- 10. Which one of the following statements is not correct in respect of setting of an inclined tunnel:
Options- A. Reference points are constructed at every 300 m.
- B. The alignment is fixed from upper/lower apex point.
- C. The level of the invert at the heading is marked by a tape.
- D. Reference points are constructed on the roof of tunnels
- E. None the above. Discuss
Structural Design Specifications problems
Search Results
Correct Answer: 1650 kg/cm2
Correct Answer: 9.0 m
Correct Answer: 25%
Correct Answer: All the above.
Correct Answer: 2.5
Correct Answer: 3 specimens
Correct Answer: 3.000 m
Correct Answer: cast iron lining
Correct Answer: ammonia dynamite
Correct Answer: None the above.
Comments
There are no comments.More in Civil Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.